Billi Sahara Plus XT Kullanıcı Kılavuzu - Sayfa 11

Sıhhi Tesisat Ürünleri Billi Sahara Plus XT için çevrimiçi göz atın veya pdf Kullanıcı Kılavuzu indirin. Billi Sahara Plus XT 16 sayfaları.

User guide

Billi Sahara & Sahara Plus – XL, XT, XR.

Filter removal and

replacement instructions

Important note: Please ensure you remove the

foam packing under the filter before installing .

1 . Remove the front panel .

2 . Place the unit in Holiday Mode by pressing

the Pressure Relief button once . The lights

on the dispenser will alternate and then go

off

3 . Hold filter and swing towards you slowly .

The top of the filter is in a hinged cradle

assembly . It should stop after approximately

30 degrees of travel .

4 . The filter can now be released from the

holding cradle by pulling down on the filter .

5 . Take care not to spill water in the base of the

tray . If so wipe gently with absorbent paper .

6 . Install new filter into the same location

by pushing all the way up into the cradle .

7 . Push filter back into the unit until it locks

into place . Power light should come back on .

8 . Flush ambient water for 1 minute .

9 . Check for any leaks from around the filter,

hosing or pipeworks .

10 . Replace the front cover .

Front

panel

Pressure

relief

button

Filter