Allied Systems LONG REACH CCHA Kurulum Bakım ve Servis Kılavuzu - Sayfa 9

Endüstriyel Ekipmanlar Allied Systems LONG REACH CCHA için çevrimiçi göz atın veya pdf Kurulum Bakım ve Servis Kılavuzu indirin. Allied Systems LONG REACH CCHA 19 sayfaları. Carton clamp with load stabilizer

Sayfayı Yazdır

• Do not cross dock boards or dock levelers with the

attachment or carriage fully lowered. Ramming the

front or rear of the attachment against a dock board

can cause severe damage.

• Limit lift truck movement to a minimum when high

stacking. Limit sideshift movement to a minimum

when high stacking.

• Always be observant when high stacking. Look for

poorly stacked loads, overhead obstacles, broken

cartons, or damaged products in the stack.

• Travel slowly around corners. Sound horn on blind

corners. Be careful of tail swing and overhead clear-

ances. Watch in all directions. Avoid sudden stops.

3.14 Operator's Controls

Some lift trucks are equipped with a single lever to

control both hoist and tilt functions, others have separate

levers for each function. Refer to your lift truck manual

for more information.

For clarity, the direction of arm movement is shown on

the control handle. To move the arms in the direction

shown, pull the handle towards the operator. To move

the arms in the opposite direction, the push the handle

away from the operator. (Figure 3-5)

Clamp

Push/pull

Rotate

Figure 3-5 Operator controls

Lifting speed is controlled by the speed of the engine

and the position of the control lever. Engine speed has

no effect on lowering speed.

45-034, REV. 5/18

Fork position

Sideshift

Before going on the job, shift the truck control levers

one way and then the other to determine which direc-

tion the attachment moves when the levers are shifted.

Make sure the attachment moves smoothly throughout

its travel, without binding or pinching hoses.

CAUTION

Equipment damage hazard.

Injury or equipment damage may result

if the attachment does NOT operate

smoothly.

Do not take malfunctioning equipment on

the job. Check with your supervisor about

needed repairs.

3.15 Industry Standards

ANSI/ITSDF B56.1-2016 is the published sequence and

direction standard for lever- and hand-type controls.

Notice

The chart on the following page shows

industry standards. Your equipment may

be different. If you do not routinely operate

this equipment, refresher training is

recommended. You must reacquaint your-

self with this manual and the equipment

before starting, and then proceed slowly.

Special controls such as automatic devices should be

identified, preferably according to the recommendations

in Figure 3-6.

When a function is controlled by a pair of push buttons,

they should operate in the same sense as the lever

controls. For example, pushing a button located to the

rear (relative to the operator's position) should serve

the same function as moving a control lever to the rear.