Aqua One NanoFlow 180 Manuel - Sayfa 5

Su Filtrasyon Sistemleri Aqua One NanoFlow 180 için çevrimiçi göz atın veya pdf Manuel indirin. Aqua One NanoFlow 180 8 sayfaları.

Sayfayı Yazdır

Installation

1. Decide on which outlet option to use.

2. If the filter is to be used in a shallow aquarium,

the filter can be turned on the side using the

elbow to direct the flow as required.

3. If the venturi is required, push the venturi

outlet directly into pump outlet, hang airline

outside of your aquarium.

4. Mount the filter to the corner of your

aquarium, secure using the suction cups on the

pump body and rear filter cover. Ensure the filter

is at a suitable height, it is recommended that

the water exiting the filter is breaking the water

surface but not splashing.

5. Ensure your hands are dry, plug the filter in at

the power outlet. Switch the power on.

6. Adjust the flow rate using the flow controller

on the top of the filter.

Maintenance

1. Ensure your hands are dry and unplug the

filter from the power supply. Take to sink.

2. Remove the pump body from the filter unit,

this will allow access to the media cartridges.

3. Remove the media cartridges from the filter

unit.

4. Rinse the sponge and squeeze gently a

few times in a bucket of aquarium water. It is

important to not wash the sponge too thoroughly

and never wash it in tap water.

Fig 1

5. Gently rinse the cartridge containing the

ceramic noodles in aquarium water. It is

important that the noodles are never washed in

tap water.

6. The carbon pouch should be replaced every

4-6 weeks. If the pouch is not being replaced, it

should be rinsed gently in aquarium water.

7. Clean the impeller at least once a month.

Accessing The Impeller

1. Grasp the pump body with one hand and filter

casing with the other and gently pull apart.

Fig 2

2. Remove the impeller cover to gain access to

the impeller.

3. Pull impeller from the motor and rinse

properly. Use an Aqua One double ended pipe

brush to clean the impeller and the impeller well

and also any of the outlet options that are being

used.

4. Put the filter back together and return to the

aquarium. Ensure your hand is not wet, plug in

at the power supply and turn on.