ABACUS Pisces Bilgi Paketi - Sayfa 5

Küvetler ABACUS Pisces için çevrimiçi göz atın veya pdf Bilgi Paketi indirin. ABACUS Pisces 17 sayfaları. Adjustable height bath

PLUMBING

(Where there are existing feeds)

This can be either wall or floor fed. Feeds should be as follows:

22mm hot water inlet; 15mm cold water inlet; 40mm Waste outlet @ 3ltr/Sec. Plumb according to Plumbing

Diagrams. Feeds should terminate with isolating valves.

Side or End Walls Feeds.

Feed & Waste – These must exit bathroom wall in either shaded area marked A. Fig 1. Pipwork should terminate

in either shaded box area paying attention to layout intended for manifold and manifold holes height – 65mm.

See Fig 2. Plumbing tails must be fitted with isolating valves.

Floor Feeds

Plumbing to exit floor and terminate in either shaded area in Fig 1. Please note layout intended for manifold and

manifold holes height – 65mm. See Fig 2. Tails c/w elbow should be left at 65mm height off floor for manifold

connection. Plumbing tails must be fitted with isolating valves.

FIG 1

Minimum distance 25mm - Wall & bath sides.

TAP END OF BATH

Abacus Pisces 069/Info.P 04/14v1a

1700 Pre Installation Requirements

FIG 2

FIG 3

Typical plumbing layout for Side or end wall