Aqua Optima Corona Kullanım Talimatları - Sayfa 3

Soğutucu Aqua Optima Corona için çevrimiçi göz atın veya pdf Kullanım Talimatları indirin. Aqua Optima Corona 3 sayfaları.

Sayfayı Yazdır

These particles are harmless and are

washed off during the preparation

process.

2. Soak the cartridge in a bowl of water

for 5-10 minutes to remove all air

bubbles.

3. Flush for 1 minute under a running tap.

4. The filter cartridge is now ready for use.

INSTRUCTIONS FOR USE

• Remove the lid and take out the upper

water tank.

• Fit the water filter cartridge into the

underside of the upper tank, rotating

clockwise to lock into place. Ensure it

is firmly secured.

• Re-insert the upper tank and pour in water until both

the tanks are full. Water will flow through the filter at a

set rate and may take some time due to the action of the

filter cartridge.

• During normal use top up the tanks regularly.

Note: If the unit has been drained it is recommended to

hold the water dispenser lever open with a glass while

filling the tanks to stop air becoming trapped inside the

unit. Once water flows through the tap, the dispensing

lever can be released.

• Fit the lid, plug the unit into the electrical mains supply

and switch on. The power/chilling light will illuminate

blue and the motor will begin to chill the water.

• Dispense 2 litres of water from the unit to remove any

unfiltered water and top up.

• When the light turns pale blue/white, the water

will be cooled to approximately 10º C less than the

ambient temperature. The motor switches on and off

automatically to keep the water constantly fresh.

• Place a glass under the dispenser and push the lever

back to dispense water.

• Top up the upper tank as required.

Note: It is possible to use the unit without power; in this

case the water will be correctly filtered but will not be

cooled.

REPLACING THE AQUA OPTIMA FILTER CARTRIDGE

Note: This water chiller is only intended for use with Aqua

Optima water filters.

• Drain the water from the tanks and remove the lid.

• Take out the upper water tank and remove the filter

cartridge by rotating it anti-clockwise.

• Insert the new filter cartridge as described previously

and refit the upper tank and lid.

FILTER LIFE INDICATOR

The electronic filter cartridge life indicator will remind you

when to change the filter cartridge and ensure optimum

performance.

AQUA OPTIMA 30-DAY FILTER CARTRIDGE

To ensure the best performance, the filter cartridge should

be changed after 100 litres, which is approximately 30 days

of typical use.

After you have fitted the filter cartridge, press and hold the

RESET button. The display will flash 30 and 60 alternately.

Keep pressing until the display shows a steady 30. This

should take approximately 4-8 seconds. When it shows a

steady 30, you can then release the button.

The display will show 30 and the counter will start. It will

count down in days from 30 to 0.

Replace the cartridge when the display reaches 00 and

begins to flash continuously.

Every time you replace the cartridge, reset the indicator

again following the above instructions. If you accidentally

set the wrong date for your filter, then simply start the

1 Min

procedure again.

AQUA OPTIMA 60-DAY FILTER CARTRIDGE

To ensure the best performance, the filter cartridge should

be changed after 200 litres, which is approximately 60

days of typical use.

After you have fitted the filter cartridge, press and hold the

RESET button. The display will flash 30 and 60 alternately.

After 4-8 seconds, it will show 30. Keep pressing until the

display shows a steady 60. This should take approximately

9-12 seconds. When it shows a steady 60, you can then

release the button.

The display will show 60 and the counter will start. It will

count down in days from 60 to 0.

Replace the cartridge when the display reaches 00 and

begins to flash continuously.

Every time you replace the cartridge, reset the indicator

again following the above instructions. If you accidentally

set the wrong date for your filter, then simply start the

procedure again.

CARE & MAINTENANCE

• Water is a foodstuff. We recommend using the filtered

water within 2 days. If the appliance is not used for more

than 48 hours fill it twice with cold water and empty the

water before continuing to use it normally.

• Should the appliance not be used for an extended

period of time (for example a holiday) we recommend

that the filter is removed and placed in a clean plastic

bag and stored in the fridge. This will help to maintain

the filter when not in use. Before using the filter after

storage, follow the preparation and fitting instructions

for use as normal.

CLEANING

ATTENTION: NEVER PLACE THE APPLIANCE BODY, PLUG

OR POWER CORD IN WATER OR OTHER LIQUIDS; ALWAYS

WIPE CLEAN WITH A DAMP CLOTH.

• Wash, rinse and dry the upper tank and the lid regularly,

at least when the filter cartridge is replaced.

• Do not use any washing-up liquid or anything that may

taint the water. Don't use harsh or abrasive cleaning

agents or solvents.

TO DRAIN THE WATER CHILLER COMPLETELY

BEFORE STORING

Remove plug from the electrical wall socket and empty

both tanks.

In the middle of the cable tidy, underneath the appliance,

is a drainage plug which must be unscrewed to remove

any residual water from the internal tank.