AVPro Edge AC-MX1616-AUHD Hızlı Başlangıç Kılavuzu - Sayfa 2
Matris Anahtarlayıcı AVPro Edge AC-MX1616-AUHD için çevrimiçi göz atın veya pdf Hızlı Başlangıç Kılavuzu indirin. AVPro Edge AC-MX1616-AUHD 4 sayfaları. 18gbps true 4k60 4:4:4 16x16 matrix (ultra low profile)
Sayfayı Yazdır
Front Panel Control
Make setup a breeze! The front panel allows you to do basic setup including; EDID,
Audio, Matrixing and network. All without connecting a PC or hooking anything up. This
additional mode of control is a welcome resource on the job site.WebOS
Switching:
The AC-MX1616-AUHD can be switched from the front panel by
ENTER, then select the
1.Press the button (1 through 16) that corresponds with the OUTPUT (Display, or Sink
Device) you would like to send a source.
2.Press ENTER
3.Now select the desired INPUT on (1 through 16)
4.The route is now set.
5.You may also navigate to the "Switch" Menu on the Control Screen to manage the routes
Navigating the Control Screen:
You can use the control screen to setup/control several key features including:
Matrix Switch Routing
•
EDID Management
•
Audio Setup & Routing
•
Output or Matrix - When in Matrix, audio route can be selected.
Network Setup
•
~ View/Setup IP Address (Host/device, Gateway, Subnet), Toggle DHCP, set
port number and view MAC Address
To navigate the control screen you have a 6-button control panel that controls the
"Control" Screen.
•"Menu" area consists of UP, DOWN, LEFT and RIGHT - These are your navigation buttons.
Press these buttons to movethrough them menus to your desired selections. Your desired
selection will be bordered or highlighted
•"Enter" Selects the highlighted item and advances to the next set of options or sets your
selection
•"Cancel" Stops what you are doing and takes you back one menu or to the home screen.
INPUT:
Step 2: press enter
~ Control switching or view the current routing
~ View and adjust EDID Configuration
~ Set the default extracted audio mode to Bind to Input, Bind to
Step 1: select the desired output
Step 3: select the desired input
selecting the OUTPUT, Press