Aqua Pulse Spas Trinity Deluxe Spa Kullanıcı Kılavuzu - Sayfa 9
Sıcak Küvet Aqua Pulse Spas Trinity Deluxe Spa için çevrimiçi göz atın veya pdf Kullanıcı Kılavuzu indirin. Aqua Pulse Spas Trinity Deluxe Spa 18 sayfaları.
Sayfayı Yazdır
To locate your drain fitting it will be found on the touchpad side of the spa in
either the left or right hand corner of the black fibreglass base underneath the
synthetic cabinet. When you want to operate the drain fitting turn the handle
clockwise and at the same time pull the handle away from the spa to release
it
from the locking keyway. When the drain fitting is pulled fully away from the
fibreglass base you can now unscrew and remove the handle by screwing it
anticlockwise. With the handle off you can now connect the supplied hose
connection and attach your garden hose, now push the drain halfway back in
toward the fibreglass base and it will begin draining the spa. Once drained
remove the garden hose and garden hose connection. Replace the handle by
screwing it on clockwise and push the drain fitting back into the fibreglass base. Once in the fibreglass base
slightly turn the handle which will prevent it from coming out when you refill the spa with water.
TURNING JETS ON & OFF
The larger jets in your spa can be turned on or off. Turning the jet face clockwise will turn the jet on which will
allow the water to flow through the jet. Turning the jet face anticlockwise will turn the jet off stopping the water from
flowing through the jet. The smaller jets in your spa can not be turned on and off, they will always remain on.
WATERFALL CONTROL HANDLE
Your waterfall control handle can be located on the spa image on page one.
When using this handle do not apply pressure to the handle at the fully open or fully closed positions you will
break the handle if you do.
To run your waterfall turn the manual heating button on and set the temperature button at least two degrees above
the current water temperature, then turn the waterfall control handle anticlockwise. To turn the waterfall off turn the
waterfall control handle clockwise until the waterfall stops running. Reduce the temperature button back to the
original temperature.
AIR CONTROL HANDLE
The air control handle can be located on the spa image on page one.
This handle controls the amount of air pressure coming from the jets, which will increase the water pressure if it is
turned anticlockwise and will decrease the water pressure if it is turned clockwise.
MAIN WATER DIVERTER
The main diverter handle can be located on the spa image on page one.
Do not turn this handle while the pumps are running and do not apply pressure to the handle at the fully open or
fully closed positions you will break the handle if you do.
This handle is used to divert the water within the spa, when you turn the handle to different positions the water
pressure will change within the spas chairs. This handle will make noise when the pumps are running, and the
noise level will vary depending on where the handle is positioned.
AROMATHERAPY CONTROL HANDLE
Your spa has an inbuilt aroma therapy stick which can be located on the spa image on page one. With all the
pumps turned off unscrew the fitting from the spa and take out the stick. Remove the plastic transport cover by
unscrewing the blue cap and sliding the opaque cover off to expose the scented stick inside, screw the blue cap
back onto the aroma stick leaving the opaque cover off. Reinstall the stick back into the spa, do not overtighten
the fitting it only needs to be lightly tightened. Turning the handle clockwise runs the aroma scent when you have
the air blower turned on and turning the handle anticlockwise will turn the aroma scent off.
MY SPA IS TOO HOT IN SUMMER, THE TEMPERATURE OF THE WATER IS HIGHER THAN I HAVE SET
During summer there may be times when the spas water exceeds the set temperature. This is not a fault in the
spa it is simply the ambient air temperature causing this. To combat this problem, you can use ice to cool down
the water.
9