Allied Telesis AT-9812T Hızlı Kurulum Kılavuzu - Sayfa 7
Anahtar Allied Telesis AT-9812T için çevrimiçi göz atın veya pdf Hızlı Kurulum Kılavuzu indirin. Allied Telesis AT-9812T 11 sayfaları. At-9800 series
Ayrıca Allied Telesis AT-9812T için: Tamamlayıcı Kılavuz (4 sayfalar), Hızlı Kurulum Kılavuzu (12 sayfalar)
Sayfayı Yazdır
Quick Install Guide
C613-04038-01 REV D
AT-9812TF and AT-9816GF models can be used with AT-RPS8000 RPS
systems, while AT-9812T and AT-9816GB models can be used with
AT-RPS9000 systems.
RPS systems can be purchased separately, contact your authorised Allied
Telesyn distributor or reseller for more information.
11. Install GBICs
Any combination of copper and fibre GBICs can be installed in the
following AT-9800 Series switches:
•
AT-9812T
•
AT-9812TF
•
AT-9816GB
For the AT-9816GF, up to fourteen 1000BASE-T GBICs can be installed. The
actual number depends on the number of fibre GBICs also installed.
Table 1 on page -7 lists the number of 1000BASE-T GBICs that can be
installed in the AT-9816GF for various copper/fibre combinations.
Table 1: GBIC configurations for the AT-9816GF.
Number of fibre GBICs installed
0
1
2
3
4 or 5
6
7
8
10 or 11
12
13
14
15
16
Slide the GBICs into the GBIC slots. Press each GBIC firmly into place.
A range of GBICs have been tested and approved for use with AT-9800 Series switches,
contact your authorised Allied Telesyn distributor or reseller for more information, or
visit www.alliedtelesyn.co.nz/support/at9800.
RX and TX terminal locations on SC fibre GBIC ports are the reverse of RX and TX
terminal locations on fixed SC fibre ports. When looking at an SC fibre GBIC from the
front, the RX terminal is on the left and the TX terminal is on the right.
12. Connect the data cables
Maximum number of 1000BASE-T GBICs that
can be installed
14
13
12
11
10
9
8
7
5
4
3
2
1
0
7