Allied Telesis AT-9816GB V2 Hızlı Kurulum Kılavuzu - Sayfa 7
Anahtar Allied Telesis AT-9816GB V2 için çevrimiçi göz atın veya pdf Hızlı Kurulum Kılavuzu indirin. Allied Telesis AT-9816GB V2 10 sayfaları. At-9800 series switch
Sayfayı Yazdır
Quick Install Guide
C613-04038-01 REV H
Configuring the Switch
Some configuration is necessary to enable the advanced switching capabilities
of the switch. The switch can be configured via the Command Line Interface
(CLI) or Graphical User Interface (GUI).
Using the CLI to configure a switch
1.
Connect a terminal or PC to RS-232 (ASYN0)
Using the supplied RS-232 DB9 straight-through cable, connect your
terminal or PC to the RS-232 Terminal Port on the switch's front panel.
2.
Set the communication parameters
Set the communication parameters on your terminal or terminal emulation
program to:
•
Baud rate: 9600
•
Data bits: 8
•
Parity: None
•
Stop bits: 1
•
Flow control: Hardware
3.
Check the power supply
Ensure that the On/Off switch (AC models) or Run/Standby switch (DC
models) is in the On or Run position and that the switch is receiving power
(Power LED lights green).
4.
Log in
After the switch has booted, the log in prompt appears. If the log in prompt
doesn't appear, press [Enter] two or three times.
When the switch boots for the first time it automatically creates an account
with manager privileges. The account has the log in name "manager" and
the password is "friend".
At the log in prompt, enter the log in name and password.
Login: manager
Password: friend
The command prompt appears and you can now configure the switch
using the command line interface.
Change the password as soon as possible. Leaving the manager account with
the default password is a serious security risk. Make sure you remember the
new password as there is no way to retrieve it if it is lost.
Use the following command to change the account password:
set password
To display a list of help topics, enter:
help
To display help on a specific topic, enter:
help topic
7