Aqua Quip InstaTouch Kullanıcı Kılavuzu - Sayfa 2

Kontrolör Aqua Quip InstaTouch için çevrimiçi göz atın veya pdf Kullanıcı Kılavuzu indirin. Aqua Quip InstaTouch 4 sayfaları. Smart lighting controller

Sayfayı Yazdır
REMOTE CONTROL HANDSET
Before you can use your handset, you will
AAA alkaline batteries
To install the batteries:
• Remove the silicone case.
• Slide the rear cover until disengage, lift the rear cover off the
body, see Diagram A.
• Install batteries, noting correct polarity, see Diagram B.
• Clip the rear cover back in place and re-fit the silicone case.
Using the Remote Control:
The handset features a "shake-to-wake" function. Once woken, the remote will stay awake for 45
seconds after any button has been pressed, then turn off.
The remote can be woken by a firm tap of the finger, or a shake. Indicator LEDs will light up for a
few seconds when the remote is woken.
The
ZONE-1, ZONE-2
lights on or off together or independently.
The ZONE-1 ON and ZONE-2 ON buttons can also be used to control the
each zone, and its brightness, without affecting the other zone. Refer to Selecting Colours and
Shows and Adjusting the Brightness.
Selecting Colours and Shows:
Pressing any of the seven
any zone which is turned on. Zones which are turned off will not be affected.
There are two ways to change the colour/show of one zone without affecting the other zone:
1. If only one zone is on: Just press the desired
2. If both zones are on: Press the
desired COLOUR/SHOW button.
Using the
COLOUR SELECT
The operation of the COLOUR SELECT button alternates between displaying your chosen colour
and scrolling through a palette of colours for your selection.
The default colour which is stored in the lights is
for the first time, the lights will display a fixed red colour.
Press the COLOUR SELECT a second time and the lights will begin scrolling through a palette
which looks like this:
S E C O N D S
1.0
3.0
5.0
Once the lights display the colour you want, press the COLOUR SELECT button again. The lights
will now hold that colour. Even if you then select a completely different fixed colour or show, or
turn the lights off, your selected colour is stored and will be displayed next time you press the
COLOUR SELECT button.
When you press the COLOUR SELECT button to start scrolling through colours again, the scroll
will start from your previously-selected colour.
2
S M A R T L I G H T I N G C O N T R O L L E R U S E R G U I D E
, included.
and
and
ZONE 1+2 ON
COLOUR
buttons or six
ZONE-ON
feature:
7.0
10.0
15.0
17.0
to install the two
need
buttons can be used to turn the pool and spa
OFF
SHOW
buttons will change the colour or show of
COLOUR/SHOW
button for the zone you want to change, then press the
RED
. When you use the COLOUR SELECT button
27.0
33.0
43.0
51.0
Diagram A
COLOUR
or
button.
57.0
63.0
80.0
Diagram B
SHOW
of
100
110