CPE 50075 Kullanıcı El Kitabı ve Kullanım Talimatları - Sayfa 8

Çim ve Bahçe Ekipmanları CPE 50075 için çevrimiçi göz atın veya pdf Kullanıcı El Kitabı ve Kullanım Talimatları indirin. CPE 50075 14 sayfaları. Garden sink

Sayfayı Yazdır

aSSeMbly

Masonry or brick mounting cont'd.

7 . Using a power hand drill or hammer drill with a

screwdriver tip bit, secure a M6x60 wood screw

(#17) into a pilot hole on the wall, through the hole

in the sink frame .

8 . Repeat for the 3 remaining holes .

9 . Tighten all screws but do not overtighten .

10 . Make sure the support frame is secure on the wall

before continuing .

installing the hose hanger

1 . Align the prongs of the hose hanger with the 2 holes

on the bottom frame cross bar .

2 . Insert the prongs into the holes . No nuts are needed

to hold in place .

nOTe

The hose hanger is designed to be easily assembled

or disassembled quickly .

installing the sink

Tools required (not included):

– Phillips screwdriver (small and medium)

– 8 mm and crescent (adjustable) wrench

instructions:

1 . Using the medium or small phillip head screwdriver,

attach the drain outlet connector (#21) to the drain

hole on the bottom of the sink with the 3 M3x10 self

tapping screws (#3) . (A)

REV 50075-20140319

installing the sink cont'd.

2 . Tighten all screws . Do not overtighten .

3 . Install the sink (#19) over the top of the frame

(#32) . (B)

4 . Line up the 2 holes in the drain hose connector (#24)

with the two holes on the bottom of the frame . These

holes will be on the right side of the frame . (C)

5 . Thread the M5x35 bolts (#29) through the drain

hose connector and frame . (C)

6 . Using the crescent (adjustable) or a 8 mm wrench

and medium phillip head screwdriver, secure the

hose connector to the frame by tightening the M5

nuts (#30) onto the M5x35 bolts . (C)

7 . Tighten both nuts . Do not overtighten .

8 . Take the storage drawer (#15, #16) and insert the

left end first, and then the right end until a snap is

heard . (D)

9 . The right end has a latch that should catch . (D)

10 . Lift the cover and fold it back into the left side of

the frame, until it sits in the groove of the sink on

the left side . (E)

50075

ENGLISH