Allied Telesis CentreCOM GS980M/52 Hızlı Kurulum Kılavuzu - Sayfa 11
Anahtar Allied Telesis CentreCOM GS980M/52 için çevrimiçi göz atın veya pdf Hızlı Kurulum Kılavuzu indirin. Allied Telesis CentreCOM GS980M/52 20 sayfaları. Gigabit ethernet switches
Sayfayı Yazdır
Warning: Do not install the switch on a wall near hot
electrical wires.
6. If the wall material requires pre-drilling the screw holes, use an
appropriate drill to drill the holes. The switch comes with four
M4x32.3mm screws.
7. If the wall material requires anchors, insert the anchors into the
screw holes. The switch comes with four M6x4x29.6 mm
anchors.
8. Have another person hold the switch at the selected wall location
while you secure it to the wall with four screws.
9. Go to "Ports" next.
Ports
Ethernet Copper Cable Specifications
The minimum cable requirements for the Ethernet copper ports are.
10Mbps or 100Mbps: Standard TIA/EIA 568-B-compliant
Category 3 unshielded cabling.
1000Mbps: Standard TIA/EIA 568-A-compliant Category 5 or TIA/
EIA 568-B-compliant Enhanced Category 5 (Cat 5e) unshielded
cabling.
Cabling Ethernet Copper Ports
Observe the following guidelines when connecting Ethernet copper
cables to the ports on the switch:
The connectors on the cables should fit snugly into the ports, and
the tabs should lock the connectors into place.
The default speed setting for the ports is Auto-Negotiation. This
setting is appropriate for ports connected to network devices that
also support Auto-Negotiation.
The ports must be set to Auto-Negotiation, the default setting, to
operate at 1000Mbps.
The ports support half- and full-duplex at 10Mbps or 100Mbps.
The ports support only full-duplex at 1000Mbps.
CentreCOM GS980M Series Quick Installation Guide
11