Allied Telesis Patch SB244-01 Yayın Notu - Sayfa 2
Anahtar Allied Telesis Patch SB244-01 için çevrimiçi göz atın veya pdf Yayın Notu indirin. Allied Telesis Patch SB244-01 4 sayfaları. Allied telesis, inc patch switch release note
Sayfayı Yazdır
2
Features in SB244-01
Patch SB244-01 includes all issues resolved and enhancements released in
previous patches for Software Release 2.4.4, and the following enhancement:
PCR: 01285
Module: OSPF
When an interface went down (or was disabled) on an AS border router, the
external routes were not removed from the routing domain. Such routes are
now removed by premature aging.
PCR: 02353
Module: SWI
The learning unit was locking under heavy load. This could result in pings
to a network device failing, and over an hour all dynamic MAC addresses
could be lost. Sometimes a large number of pause frames were generated by
the system. This issue has been resolved.
PCR: 02359
Module: IPG
When an IP Multihomed interface was used as an OSPF interface,
neighbour relationships were only established if the IP interface for OSPF
was added first in the configuration. Now, OSPF establishes neighbour
relationships regardless of the IP Multihomed interface configuration order.
PCR: 02361
Module: SWI
The SwitchBlade mirror port field on the second instance of a switch chip
was displaying as though it was the first instance. This issue has been
resolved.
PCR: 02394
Module: IPG, SWI, DVMRP
The following issues have been resolved:
•
IP route updating was not working correctly
•
IGMP snooping behaviour was incorrect
•
The SHOW DVMRP FORWARDING command displayed incorrect
port numbers.
PCR: 02396
Module: DHCP
DHCP RENEW request messages are now unicast (as defined in the RFC),
not broadcast.
PCR: 02397
Module: DVMRP
After a prune lifetime had expired, the interface was not joined back to the
DVMRP multicast delivery tree. This issue has been resolved.
PCR: 02398
Module: IPV6
The following issues have been resolved:
•
It was possible to assign the same network on different IPV6 interfaces
•
The loopback address was being added to other interfaces
•
The tunnel configuration was not showing correctly in IPV6
configuration commands
•
RIPv6 now sets the metric of routes for interfaces that are DOWN to 16,
and immediately sends responses when the link status of VLAN
interfaces changes.
Patch Release Note
Network affecting: No
Network affecting: No
Network affecting: No
Network affecting: No
Network affecting: No
Network affecting: No
Network affecting: No
Network affecting: No
Patch SB244-01 for Software Release 2.4.4
C613-10349-00 REV A