Abatement Technologies HEPA-AIRE PAS1200 Kullanım Kılavuzu - Sayfa 6
Yıkayıcı Abatement Technologies HEPA-AIRE PAS1200 için çevrimiçi göz atın veya pdf Kullanım Kılavuzu indirin. Abatement Technologies HEPA-AIRE PAS1200 18 sayfaları. Portable air scrubber
Sayfayı YazdırELECTRICAL REQUIREMENTS
1. The PAS1200s require a minimum of 110 volts AC, 60 Hz to operate properly; however, maximum air
flow performance requires 120 volts AC, 60 Hz.
2. Due to momentary start-up current surge, the unit requires a 15 amp circuit that is free of other loads.
3. Extension cords used for this unit must be UL-listed, heavy duty No. 14/3 AWG SJTW industrial grade 3-
wire type. Use of larger numerical gauge (lower capacity wire) power cord(s) may result in electrical
shock, fire hazards and/or damage to unit. The cord(s) must be in good condition and in continuous
lengths (no splicing) and should not exceed a total of 50 feet (15 meters) in length. Make certain that any
extension cords used do not reduce power to the unit to less than 110 volts. Use of a voltmeter to confirm
adequate voltage is recommended.
4. Check to ensure that any circuit to which the unit is connected is protected by a 15 amp circuit breaker.
The unit itself is equipped with a 10 amp circuit breaker.
5. The units should be connected to a three-prong, properly grounded electrical outlet equipped with a
Ground Fault Circuit Interrupt (GFCI) device. A GFCI is an electrical safety device that will trip the circuit
and stop the flow of electricity if leakage of current is detected.
Important Note: The GFCI on the PAS1200 control panel only detects leakage of current from the unit
or an electrical device plugged into the GFCI. The PAS1200 should be plugged into a GFCI receptacle
at the power source to protect the power cord and the unit. This GFCI will trip the circuit if it detects
leakage of current from the power cord or unit.
6. To avoid personal injury, fire hazards and/or damage to the unit's electrical system and power cord, do
not connect or disconnect the power cord to an electrical outlet unless the unit is switched to the "OFF"
position.
KEY COMPONENTS
4