2Wire Gateway 100 Series Kurulum Kılavuzu - Sayfa 18

Ağ Geçidi 2Wire Gateway 100 Series için çevrimiçi göz atın veya pdf Kurulum Kılavuzu indirin. 2Wire Gateway 100 Series 19 sayfaları. Usb driver installation for macintosh computers
Ayrıca 2Wire Gateway 100 Series için: Sürücü Kurulumu (1 sayfalar)

Sayfayı Yazdır

Gateway Installation and Support Guide

Appendix E: Back-Up Key Codes

In most cases, you will receive a key code from your ISP . This key code is used to activate the 2Wire

gateway. If you did not receive a key code, you can use the key codes provided in the following table.

If your Internet Service Provider gave you a PPPoE

username and password to set up your Internet

connection, your broadband connection uses Point-

to-Point Protocol over Ethernet and you should use

this key code.

If your Internet Service Provider assigned you an IP

address to set up your Internet connection, your

broadband connection uses static IP (Internet

Protocol) and you should use this key code.

If your Internet Service Provider did not provide you

with a user name, password, or IP address to set up

your Internet connection, your broadband

connection most likely uses DHCP (Dynamic Host

Configuration Protocol) and you should use this key

code.

52EU-2374-6262-22AS-B22Y

52EU-2374-2E66-22AS-B2TW

52EU-2374-2262-22AT-B222