2Wire HomePortal 5011NV Kurulum Kılavuzu - Sayfa 10

Ağ Geçidi 2Wire HomePortal 5011NV için çevrimiçi göz atın veya pdf Kurulum Kılavuzu indirin. 2Wire HomePortal 5011NV 18 sayfaları. Intelligent gateway

Sayfayı Yazdır

HomePortal® 5011NV/5012NV Intelligent Gateway Installation Guide

Connecting through Wireless

The gateway has an integrated wireless AP that enables you to connect your wireless-enabled computers to your

gateway. By default, the gateway is shipped with pre-enabled WPA-PSK/WPA2-PSK and a pre-configured

network name.

Most laptops are equipped with an internal 802.11b/g card. If your computer is not equipped with an internal

card, you can install an external wireless adapter for wireless networking.

Note

The default network name (SSID) and the encryption key (64-bit hex value) is located at the bottom

label on the side of the 2Wire gateway (for example, 1234567891). Mac OS X users may have to enter

the "$" character at the beginning of the encryption key (for example, $1234567891).

To connect the computer and the gateway using wireless AP:

Install and configure your wireless adapter, if required.

View the available wireless network connections. Use the network adapter client or Windows Wireless

Network Connection wizard to view the wireless connections.

Select the network name of the gateway from the menu, and click Connect.

A prompt to enter the network key appears.

Enter the encryption key and click Connect.

Refer the note above for the location of the key.

Once the gateway recognizes the wireless client, the WIRELESS LED turns steady green, and then starts

flickering once the wireless client starts the data transfer with the gateway.

Figure 5: Wireless Network Key Location

Note

You can configure Wi-Fi Protected Setup (WPS) for simplifying the process of connecting any home

device to the wireless network using the PIN or PUSH method. PIN method establishes the wireless

connectivity using the PIN generated by the wireless client. To do so, enter the PIN generated by the

wireless client in the Device PIN text box on the user interface of the gateway and click Connect.

PUSH method establishes the wireless connectivity if you push the WPS button found at the front panel

of the gateway followed by using the PUSH method on the client device (as advised by the OEM of the

Connecting Your Computer to the Gateway

Installing the HomePortal Intelligent Gateway