DGP DGP-3 Kullanıcı Kılavuzu - Sayfa 5

Öğütücü DGP DGP-3 için çevrimiçi göz atın veya pdf Kullanıcı Kılavuzu indirin. DGP DGP-3 13 sayfaları. Tungsten grinder
Ayrıca DGP DGP-3 için: Kullanıcı Kılavuzu (13 sayfalar)

Sayfayı Yazdır

6. OPERATOR SHOULD KNOW HOW TO USE THE GRINDER

• Only use the grinder for its intended purpose. Do not use it for a job it was not designed for. Grinding parts other

than tungsten will severely decrease wheel and equipment life.

• Unplug the grinder when changing accessories, such as collets, wheel, or other replacement parts.

• Avoid accidental start-up. Make sure that the grinder is in the off position before plugging it in.

• Do not force the grinder. It will most efficiently at the rate for which it was designed. Consult the "Recommended

Minimum Cutting and Grinding Time for New Electrodes" sticker on the grinder to determine optimum rate of speed.

• Use recommended accessories. Use of improper accessories may cause risk of injury of person or accelerated wear

on the grinder.

• Handle the tungsten and grinder correctly. Consult grinder operation procedures in this manual and handle tungsten

with pin vise whenever possible to protect hands from possible injury.

• Feed tungsten into grinding wheel against eh direction of rotation of the wheel.

• Turn the wheel off if it jams. A wheel jams when it digs too deeply into the tungsten (the motor force keeps it stuck in

the tungsten).

• Never leave the grinder unattended. Turn the grinder off first and do not leave until it comes to a complete stop.

• Never stand or lean on the grinder. Serious injury could occur if the grinder is tipped or if the cutting tool is

unintentionally contacted.

• Keep hands away from moving parts and cutting surfaces.

7. OPERATOR SHOULD BE PREPARED FOR THE JOB

• Wear proper apparel. Do not wear loose clothing gloves, neckties, bracelets, or other jewelry which may get caught

in moving parts of the machine.

• Wear protective hair covering to ctonatin long hair.

• Wear safety shoes with non-slip soles.

• Wear safety glasses. Prescription glasses have only impact resistant lenses.

• Wear face mask or dust mask.

• Be alert and think clearly. Never operate power tools when tires, intoxicated, or when taking medications that

cause drowsiness.

8. GRINDER SHOULD BE MAINTAINED PROPERLY

• Always unplug grinder before inspection.

• Keep the grinder clean for safest operation.

• Remove adjusting keys and wrenches. Form a habit of checking that keys and adjusting wrenches are removed

before the grinder is turned on.

• Keep all safety guards in place and in good working order.

• Keep all parts in working order. Check to determine that the guard or other parts will operate properly and perform

their intended functions.

• Check for damaged parts and alignment of moving parts, binding of moving parts, breakage of mounting parts, and

any other condition that may affec tthe grinders operation.

• Consult DGP factory for replacement parts at (805) 498-3837.

9. WORK AREA SHOULD BE READY FOR THE JOB

• Keep work area clean.

• Do no use power tools in dangerous environments, such as damp or wet locations. Do not expose power tools to

rain.

• Work area should be properly lighted.

• The proper electrical outlet should be available for the tool. For 110V, a three prong plug should be plugged directly

into a three prong outlet and/or extension cord.

• Keep visitors a safe distance from work area and keep children out of work place. Use padlocks, master switches,

and remove starter keys to prevent any unintentional use of power tools.

DGP-3 & DGP-3-V2 User Manual

Rev:B • 05/16/2023