Avtech AVT583 Kullanıcı Kılavuzu - Sayfa 6

Güvenlik Kamerası Avtech AVT583 için çevrimiçi göz atın veya pdf Kullanıcı Kılavuzu indirin. Avtech AVT583 14 sayfaları. Speed dome camera

Sayfayı Yazdır
Avtech AVT583 Kullanıcı Kılavuzu

CAMERA PARAMETERS

NOTE: The method below is available only when the camera is used with our brand's HD CCTV DVR.
On the DVR live view, right click to show the DVR main menu, and select "ADVANCED CONFIG" 
"DCCS". Then, select the channel which connects this camera, and click "SETUP" to enter the menu of
camera parameters.
ADVANCED CONFIG
CAMERA
DETECTION
ALERT
NETWORK
DISPLAY
RECORD
DEVICES
DCCS
NOTIFY
EXIT
Item
BRIGHTNESS
CONTRAST
HUE
SATURATION
CAMERA GUARD
CRUISE MODE
CRUISE CONFIG
AUTO TRACKING
DISPLAY ZOOM RATIO
ENABLE TILT LIMIT
PAN SPEED
TILT SPEED
VIDEO FORMAT
CH1
CH2
CH3
CH4
MENU
SETUP
F.W.
1016
DEVICE
AVTXXX
CONNECTION
OK
Description
Click the current value to manually adjust the brightness of the image. The higher the value,
the brighter the image.
Click the current value to manually adjust the contrast of the image. The higher the value,
the higher the contrast ratio.
Click the current value to manually adjust the hue of the image.
Click the current value to manually adjust the saturation of the image. The higher the value,
the more saturated the image.
Enable "GUARD LOCK" to temporarily disable the pan function of this camera and fix the
camera surveillance area.
For details, please refer to the section "CAMERA GUARD".
Select the cruise mode when the
options: AUTO PAN, SEQUENCE and CRUISE.
AUTO PAN – Pan within the range specified in CRUISE CONFIG.
SEQUENCE – Patrol based on the sequence group specified in CRUISE CONFIG.
CRUISE – Patrol based on the route recorded in CRUISE CONFIG.
The setting shown here depends on what you selected in CRUISE MODE:
AUTO PAN – Specify the range for auto pan to run.
For details, please refer to the section "AUTO PAN SETUP".
SEQUENCE – Configure a sequence group for area patrol.
For details, please refer to the section "SEQUENCE SETUP".
CRUISE – Customize the patrol route in 200 seconds.
For details, please refer to the section "CRUISE SETUP".
Set the surveillance area for auto tracking, and the tracking timeout.
For details, please refer to the section "AUTO TRACKING SETUP".
Select "ON" to show the zoom ratio on the live view.
When this function is set to "OFF", the tilt angle is just as the specifications said, but it has
the possibility to see a little bit edge of the lens shield during camera tilting.
When this function is set to "ON", the tilt angle is slightly smaller than what's said in the
specifications, but no lens shield edge is seen during camera tilting.
Set the speed for pan movement.
Set the speed for tilt movement.
Select the video format: NTSC / PAL.
is selected in the PTZ mode. There are three
4