Dell Inspiron 1010 Servis Kılavuzu - Sayfa 14

Dizüstü Bilgisayar Dell Inspiron 1010 için çevrimiçi göz atın veya pdf Servis Kılavuzu indirin. Dell Inspiron 1010 45 sayfaları. Service manual
Ayrıca Dell Inspiron 1010 için: Hızlı Başlangıç Kılavuzu (26 sayfalar)

Sayfayı Yazdır
Dell Inspiron 1010 Servis Kılavuzu
Back to Contents Page
  2-in-1 Memory and Processor Board
Dell™ Inspiron™ 1010 Service Manual 
  Removing the 2-in-1 Memory and Processor Board
  Replacing the 2-in-1 Memory and Processor Board
WARNING:
Before working inside your computer, read the safety information that shipped with your computer. For additional safety best
practices information, see the Regulatory Compliance Homepage at www.dell.com/regulatory_compliance.
 
CAUTION:
To avoid electrostatic discharge, ground yourself by using a wrist grounding strap or by periodically touching an unpainted metal
surface.
 
CAUTION:
Only a certified service technician should perform repairs on your computer. Damage due to servicing that is not authorized by Dell™ 
is not covered by your warranty.
 
CAUTION:
To help prevent damage to the system board, remove the main battery (see
computer.
 Removing the 2-in-1 Memory and Processor Board
 
1. Follow the instructions in
Before You
 
2. Remove the battery (see
Removing the
 
3. Remove the keyboard (see
 
4. Remove the palm rest (see
 
5. Remove the hard drive (see
 
6. Remove the palm rest bracket (see
 
CAUTION:
When the 2-in-1 memory and processor board is removed from the computer, store it in protective antistatic packaging (see
"Protecting Against Electrostatic Discharge" in the safety instructions that shipped with your computer).
 
7. Remove the four screws that secure the processor system board cover and the 2-in-1 memory and processor board to the system board.
1
processor system board cover
 
8. Remove the two thermal pads on the processor.
NOTE:
The thermal pads may stick to the bottom of the processor system board cover. Remove the thermal pads from the bottom of the processor
system board cover.
 
9. Use your fingertips to carefully spread apart the securing clips on either side of 2-in-1 memory and processor board connector until the board pops up.
Begin.
Battery).
Removing the
Keyboard).
Removing the Palm
Rest).
Removing the Hard
Drive).
Removing the Palm Rest
Bracket).
2
screws (4)
Removing the
Battery) before working inside the