Dell Inspiron 5160 Servis Kılavuzu - Sayfa 38

Dizüstü Bilgisayar Dell Inspiron 5160 için çevrimiçi göz atın veya pdf Servis Kılavuzu indirin. Dell Inspiron 5160 43 sayfaları. Dell inspiron 5160: quick start
Ayrıca Dell Inspiron 5160 için: Kurulum Kılavuzu (2 sayfalar)

Sayfayı Yazdır
Dell Inspiron 5160 Servis Kılavuzu
NOTE:
If the memory module is not installed properly, the computer may not boot properly. No error message indicates this failure.
 
1. Align the notch in the module edge connector with the tab in the connector slot.
 
2. Slide the module firmly into the slot at a 45-degree angle, and rotate the module down until it clicks into place. If you do not feel the click, remove the
module and reinstall it.
 
3. Replace the cover and tighten the captive screw.
NOTICE:
If the memory module cover is difficult to close, remove the module and reinstall it. Forcing the cover to close may damage your computer.
 
4. Insert the battery into the battery bay, or connect the AC adapter to your computer and an electrical outlet.
 
5. Turn on the computer.
 
If You Are Replacing the Memory
As the computer boots, it detects the memory. The system configuration information remains the same.
 
If You Are Adding or Upgrading Memory
As the computer boots, it detects the change in memory and automatically updates the system configuration information.
 
Confirming Installed Memory
To confirm the amount of memory installed in the computer, use one of the following methods:
 Click the Start button, click Help and Support, and then click Computer Information.
l
 Access the System Setup Program by pressing <F2> immediately when the DELL™ logo appears. If you wait too long and the logo for the Microsoft® 
l
Windows® operating system appears, continue to wait until you see the Windows desktop. Then shut down your computer and try again. See "Using
the System Setup Program" in your Owner's Manual.
 Optical Drive
 

Removing the Optical Drive

 
CAUTION:
Before working inside your Dell™ computer, read the safety instructions in your Product Information Guide.
NOTICE:
To prevent static damage to components inside your computer, discharge static electricity from your body before you touch any of your
computer's electronic components. You can do so by touching an unpainted metal surface.
 
1. Follow the instructions in
"Preparing to Work Inside the
 
2. Turn the computer over, and remove the M2.5 x 8-mm screw labeled "O" next to the memory module cover.
 
3. Loosen the captive screw (labeled "M") in the memory module cover, and lift the cover away from the computer.
Computer."