Dell Latitude 3000 Series Servis Kılavuzu - Sayfa 12

Dizüstü Bilgisayar Dell Latitude 3000 Series için çevrimiçi göz atın veya pdf Servis Kılavuzu indirin. Dell Latitude 3000 Series 43 sayfaları. 2-in-1
Ayrıca Dell Latitude 3000 Series için: Kurulum Kılavuzu (2 sayfalar), Kullanıcı Kılavuzu (9 sayfalar), Yardımcı Programları ve Sürücüleri Yükleme (4 sayfalar), Teknik Özellikler (6 sayfalar), Teknik El Kitabı (45 sayfalar), Teknik Özellikler (2 sayfalar), Başlangıç Kılavuzu (28 sayfalar), Kurulum Talimatları (1 sayfalar), Hızlı Başlangıç Kılavuzu (2 sayfalar), Kurulum ve Özellikler (21 sayfalar), Manuel (25 sayfalar)

Sayfayı Yazdır
Dell Latitude 3000 Series Servis Kılavuzu
NOTICE:
To connect a network cable, first plug the cable into the network wall jack and then plug it into the computer.
 
12. Connect your computer and devices to electrical outlets, and then turn them on.
 
13. Click the Start button, right-click My Computer, and then click Properties.
 
14. Click the General tab.
 
15. To verify that the memory is installed correctly, check the amount of memory (RAM) listed.
 Cards
 
CAUTION:
Before you begin any of the procedures in this section, follow the safety instructions located in the Product Information Guide.
NOTICE:
To prevent static damage to components inside your computer, discharge static electricity from your body before you touch any of your
computer's electronic components. You can do so by touching an unpainted metal surface on the computer chassis.
Your computer provides three slots for PCI cards.
 
PCI Cards
If you are installing or replacing a card, follow the procedures in the next section. If you are removing, but not replacing a card, see
If you are replacing a card, remove the current driver for the card from the operating system.
 

Installing a PCI Card

 
1. Follow the procedures in
Before Your Begin.
 
2. Unscrew and remove the filler bracket for the card slot you want to use.
 
CAUTION:
Some network adapters automatically start the computer when they are connected to a network. To guard against electrical shock, be
sure to unplug your computer from its electrical outlet before installing any cards.
 
3. Align the cutout on the bottom of the card with the crossbar in the system board connector. Gently rock the card into the connector until it is fully
seated.
Removing a PCI
Card.