Craden DP8 Tamamlayıcı Kılavuz - Sayfa 8
Yazıcı Aksesuarları Craden DP8 için çevrimiçi göz atın veya pdf Tamamlayıcı Kılavuz indirin. Craden DP8 18 sayfaları. Transaction printers
Ayrıca Craden DP8 için: Teknik Kılavuz (8 sayfalar), Kurulum Kılavuzu (2 sayfalar), Destek Masası Kılavuzu (19 sayfalar)
1. Use a spring gauge to measure the force required to raise the right end of the rear upper
roller very slightly. It should measure 6 to 8 ounces (170 to 225 gm).
2. If necessary, adjust this force by loosening the roller spring cam screw on the right side
plate and raising or lowering the cam.
3. Repeat steps 2 & 3 on the left end of the rear upper roller.
5.4.6 Auto Alignment Gate Ramp
The gate ramp is properly adjusted if the screws that mount the roller springs to the gate have
about 0.02" (0.5mm) clearance to the bottom of the side plate slots when the gate arm is at
rest against the left side plate stop. Field adjustment is usually unnecessary. If it is necessary:
1. Insert a long 3/32 Allen wrench through the slot in the input tray and loosen the ramp
adjustment screw. The input tray may be removed by removing 3 screws from the
baseplate if you are unable to locate the ramp screw through the input tray slot.
2. Hold the ramp arm against the stop on the left side plate and move the ramp adjustment
screw toward the left until the gate just begins to rise. Tighten the screw in this position
Move ramp this way to
raise gate
5.4.7 Auto Alignment Gate Height
The gate ramp must be properly adjusted (see 5.4.6) before gate height is adjusted.
1. Raise the gate by pressing 9 4 7 FUNCT A .
2. Press FUNCT to adjust gate height. The gate fingers should be as close as possible (within
0.02" or 0.5mm) to the input guide without touching it. Each press of Awill slightly raise
the gate and each press of Bwill slightly lower the gate. When the gate is at the correct
height, press ENTER.
3. Press Bto lower the gate and then press Ato check for correct gate height. Press Bto
lower the gate and CLEAR to exit the test.
Roller Shaft
34
Ramp Arm
View: Ramp arm from front of printer with input tray removed
Input Guide
Looking into the document drive. Input tray removed for clarity. Gate in "up" position
Ramp Adjustment Screw
Ramp
Roller Segments
Gate fingers
Move ramp this way to
lower gate