Dell D13M Kullanıcı El Kitabı - Sayfa 40
Masaüstü Dell D13M için çevrimiçi göz atın veya pdf Kullanıcı El Kitabı indirin. Dell D13M 50 sayfaları.
Sayfayı Yazdır
Beep code
The computer can emit a series of beeps during start-up if the display does not show errors or problems.
These series of beeps, called beep codes, identify various problems. The delay between each beep is 300
ms, the delay between each set of beeps is 3 sec, and the beep sound lasts 300 ms. After each beep and
each set of beeps, the BIOS should detect if the user presses the power button. If so, BIOS will jump out
from looping and execute the normal shutdown process and power system.
Code
1-3-2
Cause
Memory failure
Error messages
Error message
Description
Address mark not
The BIOS found a faulty disk sector or could not find a particular disk sector.
found
Alert! Previous
The computer failed to complete the boot routine three consecutive times for the
attempts at
same error. Contact Dell and report the checkpoint code (nnnn) to the support
booting this
technician
system have failed
at checkpoint
[nnnn]. For help in
resolving this
problem, please
note this
checkpoint and
contact Dell
Technical Support.
Alert! Security
The MFG_MODE jumper has been set and AMT Management features are disabled
override Jumper is
until it is removed.
installed.
Attachment failed
The floppy or hard drive controller cannot send data to the associated drive.
to respond
Bad command or
Ensure that you have spelled the command correctly, put spaces in the proper
file name
place, and used the correct pathname.
Bad error-
The floppy or hard drive controller detected an uncorrectable read error.
correction code
(ECC) on disk read
Controller has
The hard drive or the associated controller is defective.
failed
Data error
The floppy or hard drive cannot read the data. For the Windows operating system,
run the chkdsk utility to check the file structure of the floppy or hard drive. For any
other operating system, run the appropriate corresponding utility.
40