Dell D14U Kurulum ve Özellikler - Sayfa 30

Masaüstü Dell D14U için çevrimiçi göz atın veya pdf Kurulum ve Özellikler indirin. Dell D14U 37 sayfaları.
Ayrıca Dell D14U için: Kurulum ve Teknik Özellikler Kılavuzu (36 sayfalar), Kurulum ve Teknik Özellikler Kılavuzu (39 sayfalar), Kurulum ve Teknik Özellikler Kılavuzu (36 sayfalar)

Sayfayı Yazdır

Table 26. Power Management (continued)

Option

Auto On Time

Deep Sleep Control

USB Wake Support

Wake on LAN/WWAN

Block Sleep

Post behavior

Table 27. POST Behavior

Option

Adapter Warnings

Numlock LED

Keyboard Errors

Fast Boot

Extend BIOS POST Time

Full Screen Logo

BIOS setup

Description

Sets time to automatically turn on the computer. Time is kept in standard 12-hour format

(hour:minutes:seconds). Change the startup time by typing the values in the time and

AM/PM fields.

NOTE:

This feature does not work if you turn off your computer using the switch on a

power strip or surge protector or if Auto Power is set to disabled.

Allows you to define the controls when Deep Sleep is enabled.

● Disabled

● Enabled in S5 only

● Enabled in S4 and S5

Allows you to enable the USB devices to wake the computer from standby mode. The option

"Enable USB Wake Support" is selected by default

This option allows the computer to power up from the off state when triggered by a special

LAN signal. This feature only works when the computer is connected to AC power supply.

● Disabled - Does not allows the system to power on by special LAN signals when it

receives a wake-up signal from the LAN or wireless LAN.

● LAN or WLAN - Allows the system to be powered on by special LAN or wireless LAN

signals.

● LAN Only - Allows the system to be powered on by special LAN signals.

● LAN with PXE Boot - A wakeup packet sent to the system in either the S4 or S5 state,

that will cause the system to wake-up and immediately boot to PXE.

● WLAN Only - Allows the system to be powered on by special WLAN signals.

This option is Disabled by default.

Allows you to block entering to sleep (S3 state) in OS environment. This option is disabled by

default.

Description

This option lets you choose whether the system displays warning messages when you use

certain power adapters. This option is enabled by default.

Allows you to enable or disable the Numlock feature when your computer starts. This option

is enabled by default.

Allows you to enable or disable the keyboard error reporting when the computer starts. The

option Enable Keyboard Error Detection is enabled by default.

This option can speed up the boot process by bypassing some compatibility steps:

● Minimal — The system boots quickly, unless the BIOS has been updated, memory

changed, or the previous POST did not complete.

● Thorough — The system does not skip any steps in the boot process.

● Auto — This allows the operating system to control this setting (this works only when

the operating system supports Simple Boot Flag).

This option is set to Thorough by default.

This option creates an additional pre-boot delay.

● 0 seconds (default)

● 5 seconds

● 10 seconds

This option will display full screen logo if your image match screen resolution. The option

Enable Full Screen Logo is not set by default.