Dell Inspiron D06M Servis Kılavuzu - Sayfa 29

Masaüstü Dell Inspiron D06M için çevrimiçi göz atın veya pdf Servis Kılavuzu indirin. Dell Inspiron D06M 45 sayfaları. Service manual

Back to Contents Page

Power Supply

Dell™ Inspiron™ 560/570 Service Manual

Removing the Power Supply

Replacing the Power Supply

WARNING:

Before working inside your computer, read the safety information that shipped with your computer. For additional safety best

practices information, see the Regulatory Compliance Homepage on www.dell.com at the following location:

www.dell.com/regulatory_compliance.

WARNING:

To guard against electrical shock, always unplug your computer from the electrical outlet before removing the cover.

WARNING:

Do not operate your equipment with any cover(s) (including computer covers, bezels, filler brackets, front-panel inserts, etc.)

removed.

CAUTION:

Only a certified service technician should perform repairs on your computer. Damage due to servicing that is not authorized by Dell™

is not covered by your warranty.

Removing the Power Supply

1. Follow the procedures in

Before You

2. Remove the computer cover (see

3. Disconnect the DC power cables from the system board and the drives.

Note the routing of the DC power cables underneath the tabs in the computer chassis as you remove them from the system board and drives. You must

route these cables properly when you replace them to prevent them from being pinched or crimped.

4. Remove all the cables from the securing clip on the side of the power supply.

5. Remove the four screws that secure the power supply to the back of the chassis.

6. While pressing down on the power supply retention snap, slide out the power supply and lift it out.

1 power supply retention snap 2 screws (4)

Replacing the Power Supply

1. Follow the procedures in

Before You

2. Press down on the power supply retention snap and slide the replacement power supply into the chassis.

WARNING:

Failure to replace and tighten all screws may cause electrical shock as these screws are a key part of the system grounding.

3. Replace the four screws that secure the power supply to the back of the chassis.

Begin.

Removing the Computer

Cover).

4 voltage selector switch

Begin.