Allied Telesis AR441S Yayın Notu - Sayfa 6

Yazılım Allied Telesis AR441S için çevrimiçi göz atın veya pdf Yayın Notu indirin. Allied Telesis AR441S 14 sayfaları. 54266-02 patch release note
Ayrıca Allied Telesis AR441S için: Sürüm Notları (6 sayfalar)

Sayfayı Yazdır

Features in 54266-02

PCR: 40621

Module: PING

In previous releases, ping poll commands only required entry of the first

three characters of the Source IP Address (sipaddress) parameter. For

example, add ping poll=1 ip=192.168.2.10 sip=192.168.2.1. Subsequent

releases required entry of the first four parameters. This issue has been

resolved, so that it is once again possible to enter just the first three

characters.

PCR: 40646

Module: OSPF, IPG

For both RIP and OSPF, the router was adding a route with it own IP

address for NEXTHOP address. This issue has been resolved.

PCR: 40658

Module: L2TP

L2TP did not handle a change to its peer's UDP source port. If the tunnel

went through a NAT box and that NAT box was reset, then it was possible

for the remote port to change. L2TP should be able to handle this case and

update the tunnel accordingly. A similar problem occurs when a IPsec

NAT-T session (in transport mode) is re-negotiated. IPsec NAT-T uses port

translation to distinguish between multiple clients behind a NAT box. If the

IPsec session is renegotiated then the translated source port that IPsec

passes to L2TP will change. L2TP must be able to handle this case, if it

doesn't then the session will be lost. This issue has been resolved.

PCR: 40668

Module: FFILE

The router would not respond to the setting of the maxqueueseverity

parameter when configuring logging. This issue has been resolved.

PCR: 40728

Module: IPNAT

When IP NAT was configured, a router reboot could occur if a TCP RST

packet was received in which the ACK flag and at least one other flag had

been set. This issue has been resolved.

Level 3

PCR: 31225

Module: IPG

While the router was set with a CIDR interface address, when it received an

ECHO request with a network broadcast destination address for a class C

network, the router sent the ECHO reply packet. Also, the router forwarded

the ECHO request packet using a broadcast MAC address. These issues

have been resolved.

Patch Release Note

Level: 2

Level: 3

Patch 54266-02

C613-10417-00 Rev B