Dell E665 Kullanıcı El Kitabı - Sayfa 17
Sunucu Dell E665 için çevrimiçi göz atın veya pdf Kullanıcı El Kitabı indirin. Dell E665 37 sayfaları. Emc vxrail appliances on poweredge servers
Ayrıca Dell E665 için: Kurulum ve Servis Kılavuzu (23 sayfalar)
Sayfayı Yazdır
Table 15. Rear view of the system (continued)
Item
Ports, panels, or slots
8
LOM Riser Ethernet port
(slot 1)
9
USB 3.0 port (2)
10
VGA port
11
System status indicator
cable port
12
System identification
button
For more information about the ports and connectors, see the
NIC indicator codes
Each NIC on the back of the system has indicators that provide information about the activity and link status. The activity LED
indicator indicates if data is flowing through the NIC, and the link LED indicator indicates the speed of the connected network.
Figure 10. NIC indicator codes
1. Link LED indicator
2. Activity LED indicator
Table 16. NIC indicator codes
Status
Link and activity indicators are off.
Link indicator is green, and activity indicator is blinking
green.
Link indicator is amber, and activity indicator is blinking
green.
Link indicator is green, and activity indicator is off.
Icon
Description
N/A
Use the NIC ports that are integrated on the LOM riser for network
connectivity. The LOM riser contains the OCP network card.
For more information about the supported configurations, see the
Technical Specifications
Use the USB 3.0 port to connect USB devices to the system.
Use the VGA port to connect a display to the system. For more
information, see the
N/A
Enables you to connect the status indicator cable and view system
status when the CMA is installed.
Press the system ID button:
● To locate a particular system within a rack.
● To turn the system ID on or off.
To reset iDRAC, press and hold the button for 16 seconds.
NOTE:
● To reset iDRAC using system ID, ensure that the system ID
● If the system stops responding during POST, press and hold
Technical Specifications
Condition
The NIC is not connected to the network.
The NIC is connected to a valid network at its maximum port speed,
and data is being sent or received.
The NIC is connected to a valid network at less than its maximum port
speed, and data is being sent or received.
The NIC is connected to a valid network at its maximum port speed,
and data is not being sent or received.
section.
Technical Specifications
button is enabled in the iDRAC setup.
the system ID button (for more than five seconds) to enter
the BIOS progress mode.
section.
VxRail E665 Series system overview
section.
17