Dell EMC PowerEdge C6420 Referans Kılavuzu - Sayfa 17

Sunucu Dell EMC PowerEdge C6420 için çevrimiçi göz atın veya pdf Referans Kılavuzu indirin. Dell EMC PowerEdge C6420 26 sayfaları.

Serial Communication

You can use the Serial Communication screen to view the properties of the serial communication port.

Viewing Serial Communication

To view the Serial Communication screen, perform the following steps:

Steps

1. Power on, or restart your system.

2. Press F2 immediately after you see the following message:

F2 = System Setup

NOTE:

If your operating system begins to load before you press F2, wait for the system to finish booting, and then

restart your system and try again.

3. On the System Setup Main Menu screen, click System BIOS.

4. On the System BIOS screen, click Serial Communication.

Serial Communication details

About this task

The Serial Communication screen details are explained as follows:

Option

Description

Serial Port

Enables you to set the port address for serial device. This field sets the serial port address to either

Address

COM1 or COM2 (COM1=0x3F8, COM2=0x2F8).

Failsafe Baud

Specifies the failsafe baud rate for console redirection. The BIOS attempts to determine the baud rate

Rate

automatically. This failsafe baud rate is used only if the attempt fails, and the value must not be changed.

This option is set to 115200 by default.

Remote Terminal

Enables you to set the remote console terminal type. This option is set to VT100/VT220 by default.

Type

Redirection After

Enables or disables the BIOS console redirection when the operating system is loaded. This option is set

Boot

to Enabled by default.

NOTE:

You can use only Serial Device 2 for the Serial Over LAN (SOL) feature. To use console

redirection by SOL, configure the same port address for console redirection and the serial device.

NOTE:

Every time the system boots, the BIOS syncs the serial MUX setting saved in iDRAC. The

serial MUX setting can independently be changed in iDRAC. Loading the BIOS default settings from

within the BIOS setup utility may not always revert the serial MUX setting to the default setting of

Serial Device 1.

Pre-operating system management applications