Dell EMC PowerEdge XE8545 Teknik Özellikler - Sayfa 24
Sunucu Dell EMC PowerEdge XE8545 için çevrimiçi göz atın veya pdf Teknik Özellikler indirin. Dell EMC PowerEdge XE8545 33 sayfaları.
Sayfayı Yazdır
Table 33. NIC indicator codes (continued)
NIC indicator codes
Link indicator is green, and activity indicator is off.
Link indicator is amber, and activity indicator is off.
Link indicator is blinking green, and activity is off.
Power supply unit indicator codes
AC power supply units (PSUs) have an illuminated translucent handle that serves as an indicator. The indicator shows if power is
present or if a power fault has occurred.
Drive indicator codes
The LEDs on the drive carrier indicates the state of each drive. Each drive carrier has two LEDs: an activity LED (green) and a
status LED (bicolor, green/amber). The activity LED blinks whenever the drive is accessed.
NOTE:
If the drive is in the Advanced Host Controller Interface (AHCI) mode, the status LED indicator does not power on.
NOTE:
Drive status indicator behavior is managed by Storage Spaces Direct. Not all drive status indicators may be used.
Table 34. Drive indicator codes
Drive status indicator code
Blinks green twice per second
Off
Blinks green, amber, and then powers off
Blinks amber four times per second
Blinks green slowly
Solid green
Blinks green for three seconds, amber for three seconds,
and then powers off after six seconds
Using system diagnostics
If you experience an issue with the system, run the system diagnostics before contacting Dell for technical assistance. The
purpose of running system diagnostics is to test the system hardware without using additional equipment or risking data loss.
If you are unable to fix the issue yourself, service and support personnel can use the diagnostics results to help you solve the
issue.
Dell Embedded System Diagnostics
NOTE:
The Dell Embedded System Diagnostics is also known as Enhanced Pre-boot System Assessment (ePSA)
diagnostics.
24
System diagnostics and indicator codes
Condition
Indicates that the NIC is connected to a valid network at its maximum
port speed, and data is not being sent or received.
Indicates that the NIC is connected to a valid network at less than its
maximum port speed, and data is mot being sent or received.
Indicates that the NIC identify is enabled through the NIC
configuration utility.
Condition
Indicates that the drive is being identified or preparing for removal.
Indicates that the drive is ready for removal.
NOTE:
The drive status indicator remains off until all drives are
initialized after the system is powered on. Drives are not ready
for removal during this time.
Indicates that there is an expected drive failure.
Indicates that the drive has failed.
Indicates that the drive is rebuilding.
Indicates that the drive is online.
Indicates that the rebuild has stopped.