Dell Force10 S2410-01-10GE-24P Manuel - Sayfa 31
Sunucu Dell Force10 S2410-01-10GE-24P için çevrimiçi göz atın veya pdf Manuel indirin. Dell Force10 S2410-01-10GE-24P 42 sayfaları. Installing the s2410 system
Ayrıca Dell Force10 S2410-01-10GE-24P için: Uygulama Notu (6 sayfalar), Hızlı Başlangıç Kılavuzu (31 sayfalar)
Sayfayı Yazdır
In accordance with the European WEEE Directive, electrical and electronic equipment (EEE) is to be
collected separately and to be reused, recycled, or recovered at end of life. Users of EEE with the WEEE
marking per Annex IV of the WEEE Directive, as shown above, must not dispose of end of life EEE as
unsorted municipal waste, but use the collection framework available to customers for the return,
recycling and recovery of WEEE. Customer participation is important to minimize any potential effects
of EEE on the environment and human health due to the potential presence of hazardous substances in
EEE.
Dell Force10 products, which fall within the scope of the WEEE, are labeled with the crossed-out
wheelie-bin symbol, as shown above, as required by WEEE.
For information on Dell Force10 product recycling offerings, see the WEEE Recycling instructions on
iSupport at: http://www.force10networks.com/CSPortal20/Support/WEEEandRecycling.pdf.
For more information, contact the Dell Force10 Technical Assistance Center (TAC) (see
Technical Assistance Center on page
Notice to Recyclers
CAUTION: Breaking the case cover seal voids the warranty, so this procedure is only for end-of-life recycling.
To remove the lithium closed-cell clock battery:
Remove the #1 phillips screws that connect the switch cover to the body. The cover has five screws
1
across the top of the back and thirteen screws evenly spaced along the flanges that wrap underneath
the body on three sides.
The front and back of each side of the unit has #2 phillips screw holes for rack-mounting. If screws
2
are in those holes, they must also be removed.
Set the unit vertically on a bench, so that its back panel is resting on the bench.
3
Grasp each side of the cover and pull up sharply until the cover slides upwards enough to reveal the
4
inside back edge of the body.
Set the unit flat on a bench, and use one hand to restrain the body while using the other hand to slide
5
the cover forward and off the unit.
Place fingers on each side of the clock battery and lift up
6
remove batteries to avoid accidental shorting of the battery.
Figure 6-2. Removing the clock battery
34).
(Figure
). Avoid the use of metallic tools to
Contacting the
S2410 Specifications
|
31