Dell Force10 S25V Hızlı Başlangıç Kılavuzu - Sayfa 19
Sunucu Dell Force10 S25V için çevrimiçi göz atın veya pdf Hızlı Başlangıç Kılavuzu indirin. Dell Force10 S25V 27 sayfaları.
Step
Task
Set your initial console terminal settings to match the default console settings on
3
the switch.
9600 baud rate
No parity
8 data bits
1 stop bit
No flow control (console port only)
After establishing a connection, you can modify the settings to match at each
end of the connection.
S25P only: If you use the console port to download software to the switch, you
4
will probably want to raise the console baud rate. Establish a connection with
the default settings to verify the connection. Then use the lineconfig command
to access the Line Config mode, and use the serial baudrate command to raise
the baud rate on the console port. (Match the settings in your terminal access
program.)
Accessing the Console Port
Connect the RJ-45/DB-9 adapter that is shipped with the S25P system to the RJ-
45 cable.
Table 2-1. Pin Assignments for Console Port
Signal
RJ-45 Pinout
NC
NC
RXD
GND
GND
TXD
NC
NC
1
2
3
4
5
6
7
8
Installing the Software
17