Dell KY0730481 Kurulum ve Çalıştırma Kılavuzu - Sayfa 28

Sunucu Dell KY0730481 için çevrimiçi göz atın veya pdf Kurulum ve Çalıştırma Kılavuzu indirin. Dell KY0730481 36 sayfaları. Matchprint professional server v3.0 for xerox docucolor 12

Sayfayı Yazdır

Dell KY0730481 Kurulum ve Çalıştırma Kılavuzu

Printer Calibration

KODAK POLYCHROME GRAPHICS recommends daily calibration and recalibration each time the printer

is serviced.

When using supplied profiles and device links for premium medias, printer calibration must use the

Matchprint Co-Branded Xerox Color Laser Proofing Paper. This is the only premium paper authorized by

Kodak Polychrome Graphics and Xerox to accurately simulate Matchprint color.

Commercial White

Super White

Publication

Calibrate for Bond medias using the following Xerox Color Xpressions + media. The Color Profiles and

Device Links supplied for normal, heavyweight, and extra heavyweight bond were all created using the

following Xerox media:

•

Normal Bond: Xerox Digital Color Xpressions +, 24 lb., Bright 96 paper, 3R11380

•

Heavyweight Bond: Xerox Digital Color Xpressions +, 60 lb., Bright 96 paper, 3R11390

•

Extra Heavyweight Bond: Xerox Digital Color Xpressions +, 80 lb., Ultra White 98 paper,

3R5537

•

Note, all papers above are 8.5 x 11, other sizes in the media weight may be substituted for the

purpose of calibrating the Xerox DocuColor 12 LP/CP.

Important! If a media other than the recommended Xerox media is used, the following error appears:

"Caution! The media used for calibration appears to be significantly different from the Normal Bond (or

Heavyweight) media recommended for used with this application. Results of the calibration on this media

may not be typical."

Printer calibration can be performed internally by using the DocuColor 12 built-in scanner or by using the

Spectrostar Spectrocam, an external measurement device. Both procedures are described in this section.

If calibration is to be performed using the Spectrocam, please go through the following Spectrocam

Setup instructions before beginning the calibration process.

If calibration is to be performed using the DocuColor 12 scanner, please skip to the section titled,

Calibration Procedure.

DocuColor 12 scanner, please skip to the section titled, Calibration Procedure.

Spectrocam Setup

1. Shut down the computer.

2. Connect the Spectrocam to the COM 1 (or appropriate) serial port on the back of the Matchprint

Professional Server.

3. Plug the Spectrocam power connector into the AC adapter and then plug the AC adapter into a

power outlet.

4. Power on the computer.

5. Launch the Matchprint Professional Server software.

Page 28 of 36

Matchprint Professional Server IIx for Xerox: Hardware Installation and Startup

3R12266

3R12267

3R12271

12 x 18