Dell PowerEdge 2410 Manuel - Sayfa 11

Sunucu Dell PowerEdge 2410 için çevrimiçi göz atın veya pdf Manuel indirin. Dell PowerEdge 2410 11 sayfaları. Cabling poweredge t610
Ayrıca Dell PowerEdge 2410 için: Manuel (20 sayfalar), Manuel (20 sayfalar), Manuel (17 sayfalar), Manuel (12 sayfalar), Manuel (10 sayfalar), Manuel (10 sayfalar), Manuel (9 sayfalar), Manuel (9 sayfalar), Manuel (10 sayfalar), Manuel (12 sayfalar), Manuel (8 sayfalar)

Sayfayı Yazdır

Cable Routing Procedures for Dell™ PowerEdge™ R515 Systems

Figure 10: Replacing the Outer Power Supply

Section 4: Cabling a PowerEdge™ R515 System Installed in Static Rails

NOTE: The CMA is compatible with the sliding rails only, not the static rails.

Follow the instructions contained in the

to install the server into a two-post or four-post rack.

2. Install the hook and loop straps provided in the rail kit through the slots in the rear brackets of

the rails as described in the

3. Connect all applicable cables to the rear of the system and verify that all connections are

secure.

4. Using the hook and loop straps, bundle the cables and secure them to either the left rail or

right rail as described in the

cables that are secured to the left rail and power cables that are secured to the right rail (as

viewed from the rear of the system).

Figure 11: Cabling a System Installed in Static Rails

Rack Installation Instructions

Disconnected inner

CMA bracket

found in the static rail kit

. See Figure 11 for an example of data

Page 9