Dell PowerEdge 2500 Manuel - Sayfa 3
Sunucu Dell PowerEdge 2500 için çevrimiçi göz atın veya pdf Manuel indirin. Dell PowerEdge 2500 15 sayfaları. Wake-on-lan (wol) support on dell servers
Ayrıca Dell PowerEdge 2500 için: Yapılandırma Kılavuzu (10 sayfalar), Etkinleştirme Kılavuzu (24 sayfalar), Kurulum Kılavuzu (10 sayfalar), Ataşman Kılavuzu (10 sayfalar)
Sayfayı Yazdır
1
Section
Introduction
This paper provides step‐by‐step instructions for using Wake‐On‐LAN (WOL)
with Dell™ Servers.
Definition
Wake‐On‐LAN allows a server to be remotely powered on. Wake‐On‐LAN
technology resides in a server's managed network interface card (NIC) and/or in
a LAN‐on‐motherboard (LOM) integrated network connection.
When a WOL enabled system is placed in a power saving mode (hibernate,
standby, power off, etc...), the managed NIC or LOM uses the auxiliary power
source to monitor the network and receive a wake‐up packet. When a wake‐up
packet is received, the system powers up as normal.
Prerequisites
Tools
The following tools are necessary to have on hand before using wake‐on‐LAN on
a Dell server:
1. DOS bootable floppy disk, MS DOS version 6.0 or newer, FreeDOS or
DRDOS (APM WOL only.)
2. IBAUTIL.EXE version 4.02.02.01 or newer for Intel network interface cards
(NICs) or Intel‐based LANs on Motherboard (LOMs).
3. B57UTIL.EXE version 10.11 or newer or B57UDIAG.EXE version 6.04 or
newer for Broadcom NICs or Broadcom‐based LOMs.
4. UXdiag.exe version 1.3.1 or newer for Broadcom NetXtreme II NICs or
LOMs.
5. Ethtool 1.8.4 or better for Linux WOL (Dell Servers support Red Hat
Enterprise Linux® and SUSE® Enterprise distributions of Linux.)
6. The latest BIOS for each system to use WOL.
October 2007
Page 3
Dell Enterprise Product Group