Dell PowerEdge 2650 Kurulum Kılavuzu - Sayfa 19

Sunucu Dell PowerEdge 2650 için çevrimiçi göz atın veya pdf Kurulum Kılavuzu indirin. Dell PowerEdge 2650 26 sayfaları. Activating the integrated raid controller
Ayrıca Dell PowerEdge 2650 için: Kurulum Kılavuzu (32 sayfalar), Bilgi Güncellemesi (14 sayfalar), Kurulum Kılavuzu (20 sayfalar), Kurulum Kılavuzu (40 sayfalar), Değiştirme Kılavuzu (28 sayfalar), Talimatlar Kılavuzu (8 sayfalar), Manuel (42 sayfalar), Manuel (15 sayfalar), Manuel (42 sayfalar)

support.dell.com

Installing the Systems in the Rack

The subsections that follow include instructions for installing the systems in the rack.

CAUTION: If you are installing more than one system, install the first sys-

tem in the lowest available position in the rack. Never pull more than one

component out of the rack at a time.

Pull the two interior slide assemblies out of the rack until they lock in the

extended position.

CAUTION: Because of the size and weight of the system, never attempt to

install the system in the slide assemblies by yourself.

NOTE: Skip to step 3 if your system does not have the optional bezel installed.

Remove the optional bezel from the system front panel (see Figure 1-9):

Unlock and open the system doors.

Pivot the two locking levers toward the back of the chassis (see Figure 1-9).

Press the tab on each end of the bezel and remove the bezel from the

chassis.

Close the system doors.

Lift the system into position.

Place one hand on the front-bottom of the system and the other hand on the

back-bottom of the system.

Tilt the system while aligning the back shoulder nuts on the sides of the system

with the back slots on the slide assemblies (see Figure 1-10).

tabs (2)

Rack Installation Guide

locking levers (2)

1-11