Dell PowerEdge M915 Manuel - Sayfa 5

Sunucu Dell PowerEdge M915 için çevrimiçi göz atın veya pdf Manuel indirin. Dell PowerEdge M915 25 sayfaları. Dell poweredge blade servers getting started guide
Ayrıca Dell PowerEdge M915 için: Sürüm Notları (27 sayfalar), Kullanıcı Kılavuzu (23 sayfalar), Önemli Bilgiler Kılavuzu (35 sayfalar), Başlangıç Kılavuzu (12 sayfalar), Başlangıç Kılavuzu (12 sayfalar), Kullanıcı El Kitabı (3 sayfalar), Portföy Kılavuzu (27 sayfalar), Başlangıç Kılavuzu (14 sayfalar), Başlangıç Kılavuzu (12 sayfalar)

About this Manual

This manual describes the installation and basic use of the Dell 10Gb Ethernet Pass Through -k

for M1000e.

This manual is intended for users and system administrators responsible for installing and setting

up the I/O module.

Table 2 - Abbreviations and Convention

Term

IOM

PTM

Downlink

Uplink

SSH

CMC

Component

Component numbering

http://support.dell.com/support/

Definition

I/O Module

Pass Through Module

Internal link – from servers to 10GbE PTM PHY (through the mid plane connector)

External link – from 10GbE PTM PHY to external link (typically connected to Ethernet switch)

Secure Shell (also refers to a software program that allows connectivity using an SSH protocol.)

Chassis Management Controller

10GbE PTM PHY device

Components are numbered from one (1) to three (3).

When looking at the 10GbE PTM component side with external connectors (uplink) up, the compo-

nents are numbered as follows:

Device number 1 is the right-most component

Device number 2 is the middle component

Device number 3 is the left-most component

Wherever applicable, device number 0 refers to the on-board micro-controller

Rev 1.00