Dell PowerEdge PDU Managed LED Manuel - Sayfa 9

Sunucu Dell PowerEdge PDU Managed LED için çevrimiçi göz atın veya pdf Manuel indirin. Dell PowerEdge PDU Managed LED 9 sayfaları. Site planning guide
Ayrıca Dell PowerEdge PDU Managed LED için: Manuel (20 sayfalar), Manuel (20 sayfalar), Manuel (17 sayfalar), Manuel (12 sayfalar), Manuel (10 sayfalar), Manuel (10 sayfalar), Manuel (9 sayfalar), Manuel (10 sayfalar), Manuel (12 sayfalar), Manuel (12 sayfalar), Manuel (11 sayfalar), Manuel (8 sayfalar), Manuel (11 sayfalar), Manuel (11 sayfalar), Manuel (11 sayfalar), Manuel (9 sayfalar), Saha Planlama Kılavuzu (8 sayfalar)

Dell PowerEdge PDU Managed LED Manuel
Cable Routing Procedures for Dell™ PowerEdge™ R715 Systems
Section 3: Replacing a Power Supply on a PowerEdge™ R715 System With a
CMA

3.1 Replacing a Power Supply with a Left-Side Mounted CMA

1.
If the bottom power supply must be replaced, then remove the tray from underneath the CMA
as described in the
supply must be replaced, this step can be skipped.
2. Swing the CMA to its service position.
3. Disconnect the power cord from the power supply and disengage the strain relief.
4. Replace the power supply.
5. Plug in the power cord, re-engage the strain relief, replace the CMA support tray (if it was
removed), and return the CMA to the closed (retracted) position.

3.2 Replacing a Power Supply with a Right-Side Mounted CMA

1.
If the bottom power supply must be replaced, then remove the tray from underneath the CMA
as described in the
supply must be replaced, this step can be skipped.
2. Swing the CMA to its service position.
3. Disconnect the power cord from the power supply and disengage the strain relief.
4. Disconnect both CMA attachment housings from the rail as shown in Figure 8.
5. While supporting the CMA with one hand, remove and replace the power supply with the
other hand as shown in Figure 8.
6. Reconnect the CMA attachment housings to the rail.
7. Plug in the power cord, re-engage the strain relief, replace the CMA support tray (if it was
removed), and return the CMA to the closed (retracted) position.

Figure 8: Replacing the Power Supply

CMA Installation Instructions
CMA Installation Instructions
provided with the CMA kit. If the top power
provided with the CMA kit. If the top power
CMA attachment housings
have been disconnected.
Page 7