Dell POWEREDGE R710 Manuel - Sayfa 5

Sunucu Dell POWEREDGE R710 için çevrimiçi göz atın veya pdf Manuel indirin. Dell POWEREDGE R710 9 sayfaları. Poweredge series
Ayrıca Dell POWEREDGE R710 için: Kullanıcı Kılavuzu (28 sayfalar), Dokümantasyon Güncellemesi (14 sayfalar), Bilgi Güncellemesi (14 sayfalar), Bilgi Güncellemesi (38 sayfalar), Güncelleme Kılavuzu (14 sayfalar), Güncelleme Kılavuzu (14 sayfalar), Portföy Kılavuzu (27 sayfalar), Teknik Özellikler (2 sayfalar)

Cabling the Dell™ PowerEdge™ R710

2.2 Route the Power Cables Through the Strain Reliefs

After the tray and cables are installed, route the power cables through the strain reliefs located on the power

supply handles as shown in Figure 2.

Figure 2: Routing Power Cables Through the Strain Reliefs

2.3 Routing the Cables Through the CMA

NOTE: The CMA can be installed on either the right or left rear side of the rails. Mounting the CMA on the side

opposite the power supplies (left side mount) is recommended; otherwise, the CMA must be disconnected in order

to remove the outer power supply. Refer to "Replacing a Power Supply on a PowerEdge R710 with CMA" later in

this white paper for details on power supply replacement.

NOTE: For guidelines on how to route cables within the rack, refer to the Dell White Paper "Best Practices Guide

for Rack Enclosure".

Left Side Mounting Instructions

1. Install the CMA on the left rear side of the rails by attaching both CMA housings to the attachment brackets on

the rails. See Figure 3.

2. Route the cables through the CMA while keeping any twisting of the cables to a minimum. If the cable bundle

includes a KVM dongle, place the dongle inside the CMA basket. Use the hook and loop straps on the CMA to

secure the cables.

Page 3