Dell PowerVault MD3200 Series Dağıtım Kılavuzu - Sayfa 29

Sunucu Dell PowerVault MD3200 Series için çevrimiçi göz atın veya pdf Dağıtım Kılavuzu indirin. Dell PowerVault MD3200 Series 38 sayfaları. Storage arrays
Ayrıca Dell PowerVault MD3200 Series için: Güncelleme Kılavuzu (32 sayfalar), Raf Kurulum Talimatları (2 sayfalar), Destek Matrisi (12 sayfalar), Kurulum Kılavuzu (18 sayfalar), Dağıtım Kılavuzu (38 sayfalar), Bilgi Güncellemesi (1 sayfalar), Destek Matrisi (17 sayfalar), Teknik El Kitabı (40 sayfalar), Beyaz Kitap (22 sayfalar), Dağıtım Kılavuzu (38 sayfalar)

Sayfayı Yazdır
Dell PowerVault MD3200 Series Dağıtım Kılavuzu

Post Installation Tasks

Before using the PowerVault™ MD3200 Series storage array for the first time,
complete a number of initial configuration tasks in the order shown. These
tasks are performed using the MD Storage Manager (MDSM) software.
1 For out-of-band management, you must set the network configuration for
2 Start MDSM.
3 In the Enterprise Management Window (EMW), go to Setup Add
Downloaded from
www.Manualslib.com
each RAID controller module, including its Internet Protocol (IP) address,
subnetwork mask (subnet mask), and gateway.
NOTE:
You can set the network configuration using a DHCP server.
®
•
On Microsoft
Windows
ProgramsDellMD Storage ManagerModular Disk Storage
Manager Client.
•
On Linux operating systems, click the MD Storage Manager desktop
icon. You can also launch MD Storage Manager in Linux by running
the following commands at the command prompt:
cd
/opt/dell/mdstoragesoftware/mdstoragemanager/c
lient
./SMclient
Storage Array and start the automatic discovery of systems.
NOTE:
Only storage arrays configured with IP address on the same subnet as
the management stations will be detected.
NOTE:
It may take several minutes for the discovery process to complete.
Closing the Automatic Discovery Status window before this stops the
discovery process.
After discovery is complete, a confirmation screen appears. Click Close to
close the screen.
manuals search engine
®
operating systems, click Start
Post Installation Tasks
4
29