Dell D825TM Servis Kılavuzu - Sayfa 11

Monitör Dell D825TM için çevrimiçi göz atın veya pdf Servis Kılavuzu indirin. Dell D825TM 32 sayfaları. D-1 chassis color monitor
Ayrıca Dell D825TM için: Servis Kılavuzu (33 sayfalar)

Sayfayı Yazdır

1. Color Monitor

2-4. PICTURE TUBE REMOVAL

Four screws

(Tapping screw 5)

REMOVAL OF THE ANODE-CAP

NOTE: Short circuit the anode of the picture tube and the anode cap to the metal chassis, CRT shield or carbon painted on the CRT, after

removing the anode.

REMOVAL PROCEDURES

Turn up one side of the rubber cap in

the direction indicated by arrow

HOW TO HANDLE AN ANODE-CAP

Do not use sharp objects which may cause damage to the surface

of the anode-cap.

Do not squeeze the rubber covering too hard to avoid damaging

the anode-cap. A material fitting called a shatter-hook terminal is

built into the rubber.

Do not force turn the foot of the rubber cover. This may cause the

shatter-hook terminal to protrude and damage the rubber.

Demagnetization coil

Tension spring

A board

Neck assy

Deflection yoke

Picture tube

Anode cap

Two degaussing

coil holders

Use your thumb to pull the rubber cap

firmly in the direction indicated by

arrow

Two degaussing

coil holders

Stand assy

(D board)

Cushion

— 11 —

D825TM

Two screws

(BVTP 4 x 16)

When one side of the rubber cap sepa-

rates from the anode button, the anode-

cap can be removed by turning the rub-

ber cap and pulling it in the direction of

arrow