Dell DX6004S Kullanıcı Kılavuzu - Sayfa 37

Depolama Dell DX6004S için çevrimiçi göz atın veya pdf Kullanıcı Kılavuzu indirin. Dell DX6004S 46 sayfaları. Document
Ayrıca Dell DX6004S için: Tamamlayıcı Kılavuz (4 sayfalar), Kurulum ve Yapılandırma Kılavuzu (43 sayfalar), Kurulum ve Yapılandırma Kılavuzu (35 sayfalar), Başlangıç Kılavuzu (28 sayfalar), Uyarı (28 sayfalar), Uyarı (20 sayfalar), Genel Bakış (19 sayfalar), Yapılandırma Kılavuzu (9 sayfalar), Yapılandırma Kılavuzu (9 sayfalar), Yayın Notu (8 sayfalar), Yapılandırma Kılavuzu (7 sayfalar), Yayın Notu (6 sayfalar), Yayın Notu (5 sayfalar), Sürüm Notları (5 sayfalar), Başlangıç Kılavuzu (49 sayfalar)

7 To keep the mount path persistent across reboot, add the mount path to

/etc/fstab. For example, run the following command:

vi /etc/fstab

Table 5-2 lists the options that must be selected to create a mount path.

Table 5-2. Options to Create a Mount Path

# device name Mount

Path

/dev/sdb1

/u01

Reinstalling the DX Cluster Services Node

Software

The DX Cluster Services Node software requires access to both the external

network and to a dedicated internal network. The internal private network

ensures that the DX Storage Cluster traffic is protected from unauthorized

access and that the external network is isolated from both the PXE boot

server and cluster multicast traffic. The DX Cluster Services Node software

automatically allocates the first half of the Ethernet ports detected on each

NIC interface card to the external network and the second half of the

Ethernet ports detected on each NIC interface card to the internal network.

All NICs allocated to a network are bonded into a bond interface using

mode 6 or balance alb bonding. For example, on a server with four LOM ports

and a quad port NIC adapter, LOM ports 0-1 and NIC adapter ports 0-1 are

allocated to the external network in a balance-alb bond interface and LOM

ports 2-3 and NIC adapter ports 2-3 are allocated to the internal network in a

balance-alb bond interface.

NOTE:

Network switch configuration is outside the scope of the DX Cluster

Services Node software. Switches must be properly configured by a system

administrator to ensure correct connectivity and bonding mode support.

Administrators must not connect the configured internal network ports to the

external network.

fs type

options

ext3

defaults

dump-freq pass-num

Disaster Recovery