Dell EMC Integrated Data Protection Appliance DP4400 Donanım Kurulum Kılavuzu - Sayfa 4
Depolama Dell EMC Integrated Data Protection Appliance DP4400 için çevrimiçi göz atın veya pdf Donanım Kurulum Kılavuzu indirin. Dell EMC Integrated Data Protection Appliance DP4400 18 sayfaları. Emc integrated data protection appliance
Sayfayı Yazdır
- 1. Table of Contents
- 2. Installation Overview
- 3. Prepare the Site and Unpack the System
- 4. Install Network Validation Tool
- 5. Install the Rails
- 6. Secure the Rails to the Cabinet
- 7. Install the System in the Cabinet
- 8. Install the Bezel
- 9. Connect the System to the Network
- 10. Connect the Power Cables and Power on
- 11. Configure Idrac
- 12. Installing the Dataprotection-ACM Pre-Installation Patch
- 13. Launch the Appliance Configuration Manager
- 14. Additional Resources
Hardware Installation Guide
Integrated Data Protection Appliance DP4400 2.4 Hardware Installation Guide
4
Note that all components must run on a single VLAN or subnet with the
exception of the iDRAC interface, which can be on a separate subnet or VLAN.
For further information about IP addresses, see
Note
The DP4400 installation requires IP addresses strictly from a single subnet
having a single gateway.
2. Register the 13 IP addresses in DNS with forward and reverse lookup entries for
each address. Ensure that the router for the 13 IP addresses can be pinged.
Note
When you reserve the IP addresses, you must assign the IP addresses to the
hostnames in the DNS server. Ensure that the hostnames that are assigned to
the point products do not have an underscore (_). If the hostnames have an
underscore (_), the configuration fails.
Note
Ensure that ICMP is enabled in your network environment. The deployment of
the appliance fails if ICMP is disabled.
3. Download the license files for Data Domain Virtual Edition (DDVE), Avamar
Virtual Edition (AVE), and Data Protection Advisor (DP Advisor) from the Dell
EMC Software Licensing Central.
Note
For DP4400, only during the initial activation, the license keys are automatically
downloaded from the ELMS server if the appliance is connected to the internet.
The contact person mentioned on your sales order should have received the
License Authorization Code (LAC) letter through an email during the order
fulfillment process. The LAC letter includes the license authorization code
associated with your order, instructions for downloading software binaries, and
instructions for activating the entitlements online through Dell EMC Software
Licensing Central.
Follow the steps mentioned in the LAC letter to activate the software and
download the license keys. For additional information, see the Standard
Activation Process section in the License Activation Guide .
Note
The LAC letter has the link https://licensing.emc.com/deeplink/
<LAC> which directs you to Dell EMC Software Licensing Central.
unique alphanumeric value that is mentioned in your LAC letter.
After the activation is complete, download the license keys that are generated
for Data Domain Virtual Edition (DDVE), Avamar Virtual Edition (AVE), and Data
Protection Advisor (DP Advisor). Use these license keys during the IDPA
configuration.
Table 1
on page 5.
<LAC> is a