Dell POWER VAULT 130T LIBRARY 130T Güvenlik Kitapçığı - Sayfa 9

Depolama Dell POWER VAULT 130T LIBRARY 130T için çevrimiçi göz atın veya pdf Güvenlik Kitapçığı indirin. Dell POWER VAULT 130T LIBRARY 130T 10 sayfaları. Tape library
Ayrıca Dell POWER VAULT 130T LIBRARY 130T için: Kurulum Kılavuzu (13 sayfalar)

Sayfayı Yazdır

English Version of Service Manual

Safety Notices

S01

If you are replacing a FRU or CRU because of a fault symptom code (FSC), run diagnostic

tests to make sure you can duplicate the problem. After you have replaced the FRU or

CRU, run the diagnostic tests again to make sure the problem has been fixed.

Caution: Review the following steps before attempting to remove and replace

any FRUs or CRUs.

Follow the safety and electrostatic discharge (ESD) precautions outlined in About this

Manual at the beginning of this document.

Follow the safety precautions outlined in Rack-Mounted Library Safety and

Precautions in About this Manual.

Read each procedure completely to familiarize yourself with the warnings and steps

involved with the procedure before starting.

End all jobs being performed by the library and place the tape drives offline before

removing power. Removing power without placing the drives offline could result in

loss of data or damage to the cartridge tape.

Caution: Possible equipment problems: Observe these SCSI bus precautions

when disconnecting the SCSI cables from the PowerVault 130T library and tape

drives.

•

Before connecting the external SCSI cables, make sure there is no activity on the SCSI

bus. The host must be quiesced; do not connect to a hot bus.

•

All signals must be terminated at each end of the SCSI bus. Do not mix single-ended

and differential terminators.

S02

Warning: Possible physical injury! When the Tape Drive assembly is not installed

into the PowerVault 130T, DO NOT apply power.

Safety Booklet

1-3