Dell PowerEdge 2850 Kullanıcı Kılavuzu - Sayfa 16

Depolama Dell PowerEdge 2850 için çevrimiçi göz atın veya pdf Kullanıcı Kılavuzu indirin. Dell PowerEdge 2850 30 sayfaları. Dell server quick reference
Ayrıca Dell PowerEdge 2850 için: Kurulum Kılavuzu (32 sayfalar), Destek Matrisi (21 sayfalar), Tamamlayıcı Kılavuz (20 sayfalar), Bilgi Güncellemesi (24 sayfalar), Manuel (44 sayfalar), Hızlı Referans (2 sayfalar)

Sayfayı Yazdır

Back to Contents Page

Using the System Setup Program

Dell™ PowerEdge™ 2850 Systems User's Guide

Entering the System Setup Program

System Setup Options

System and Setup Password Features

Disabling a Forgotten Password

Asset Tag Utility

Baseboard Management Controller Configuration

After you set up your system, run the System Setup program to familiarize yourself with your system configuration and optional settings. Record the

information for future reference.

You can use the System Setup program to:

Change the system configuration stored in NVRAM after you add, change, or remove hardware

Set or change user-selectable options—for example, the time or date

Enable or disable integrated devices

Correct discrepancies between the installed hardware and configuration settings

Entering the System Setup Program

1. Turn on or restart your system.

2. Press <F2> immediately after you see the following message:

<F2> = Setup

If your operating system begins to load before you press <F2>, allow the system to finish booting, and then restart your system and try again.

NOTE:

To ensure an orderly system shutdown, see the documentation that accompanied your operating system.

Responding to Error Messages

You can enter the System Setup program by responding to certain error messages. If an error message appears while the system is booting, make a note of

the message. Before entering the System Setup program, see "System Beep Codes" and "System Messages" in your Installation and Troubleshooting Guide for

an explanation of the message and suggestions for correcting errors.

NOTE:

After installing a memory upgrade, it is normal for your system to send a message the first time you start your system.

Using the System Setup Program

Table 3-1

lists the keys that you use to view or change information on the System Setup program screens and to exit the program.

Table 3-1. System Setup Program Navigation Keys

Keys

Up arrow or <Shift><Tab>

Down arrow or <Tab>

Spacebar, <+>, <–>, left and right arrows Cycles through the settings in a field. In many fields, you can also type the appropriate value.

<Esc>

<F1>

NOTE:

For most of the options, any changes that you make are recorded but do not take effect until you restart the system.

System Setup Options

Main Screen

Action

Moves to the previous field.

Moves to the next field.

Exits the System Setup program and restarts the system if any changes were made.

Displays the System Setup program's help file.