Dell PowerVault 224F Kurulum Kılavuzu - Sayfa 8
Depolama Dell PowerVault 224F için çevrimiçi göz atın veya pdf Kurulum Kılavuzu indirin. Dell PowerVault 224F 24 sayfaları. Dell powervault 110t dlt vs160 tape drive - user's guide
Ayrıca Dell PowerVault 224F için: Kullanıcı Kılavuzu (23 sayfalar), Kullanıcı Kılavuzu (39 sayfalar)
Sayfayı Yazdır
1-4
Upgrade Installation Guide
Upgrading the RAID Controller
Perform the following steps to install the Dell Fibre Disk RAID Controller.
NOTICE: This product is to be used with the PowerVault 660F or a
PowerVault 224F that has been upgraded to a PowerVault 660F. See the
Dell PowerVault 660F and 224 Storage Systems Installation and Trouble-
shooting Guide for additional installation and safety instructions.
See the manufacturer's installation instructions to install the HBA in the host system.
See the installation instructions in the Dell PowerVault 660F and 224F Storage Sys-
tems Installation and Troubleshooting Guide
NOTICE: In a single-controller installation, the controller must be installed
in slot 0. If a single controller is installed in slot 1, the controller will not
boot. See Figure 1-2 for slot locations.
1.
To add a second controller, use the Phillips-head screwdriver to loosen the cap-
tive screws on the input/output (I/O) module. See Figure 1-2.
2.
Carefully pull the I/O module from slot 1 in the storage system
3.
Insert the controller slot 1 and push firmly until it is seated. See Figure 1-2.
PowerVault 660F or 224F
storage system
I/O slot 1
Figure 1-2. Installing the Dell Fibre Disk RAID Controller
Dell Fibre Disk
RAID Controller
I/O slot 0
captive
screws