Dell PowerVault DX6104 Kullanıcı Kılavuzu - Sayfa 27

Depolama Dell PowerVault DX6104 için çevrimiçi göz atın veya pdf Kullanıcı Kılavuzu indirin. Dell PowerVault DX6104 39 sayfaları. Dx object storage platform
Ayrıca Dell PowerVault DX6104 için: Başlangıç Kılavuzu (8 sayfalar), Başlangıç Kılavuzu (10 sayfalar), Manuel (37 sayfalar), Yayın Notu (16 sayfalar), Manuel (12 sayfalar), Manuel (24 sayfalar), Manuel (23 sayfalar)

Dell PowerVault DX6104 Kullanıcı Kılavuzu
11. Remove the USB key.
The RM USB key is created.

Creating A Restore Manger USB Drive On Linux Or Unix Systems

NOTE: Before you begin, ensure that you have downloaded the RM image file from dell.com/support/downloads.
To create an RM USB drive on a Linux or Unix system:
1.
Copy the RM image file to the Linux or Unix system.
2.
Insert the USB key on the Linux or Unix system.
3.
Note the name of the device that is reported by the operating system.
For example: /dev/sdc.
NOTE: Do not locally mount the USB device to a file system at this time.
4.
Copy the RM image to the USB key using the following command: dd if=<path to .img file> of=<usb
device> bs=4096k
For example: dd if=/root/DX-RM-1.0.0.img of=/dev/sdc bs=4096k

Executing The Restore Manager

To execute the RM:
1.
Insert the RM USB key on to the DX system.
NOTE: You can remotely mount the RM USB key using the iDRAC virtual media option. For more information,
see "Configuring and Using Virtual Media" of the
Guide at dell.com/support/manuals.
2.
When the system is initially booting, press <F11> to enter the BIOS Boot Manager utility.
3.
In the BIOS Boot Manager utility, select the USB key as the boot device and press <Enter>.
RM boots from the USB key and the recovery mode options (Appliance Recovery and Factory Reset) are displayed.
In the warning message displayed on the screen, make a note of the access code. This code is required in the
subsequent steps. For example,
WARNING: This operation is irreversible and will attempt to preserve data
and recover the system. Refer to the documentation before proceeding. Enter
the following string at the prompt to proceed: recovermysystem
4.
If you select Factory Reset as the recovery mode option:
CAUTION: The Factory Reset mode permanently erases all your settings. Use this mode only under the
guidance of Dell Support.
a) Enter the access code and follow the on-screen instructions.
A screen is displayed which shows the versions of the RM and the DX system.
b) Click Next.
The RM installs the operating system and a message is displayed prompting you to restart the system.
c) Click Reboot to restart the system.
The RM completes installing the DX system software, drivers, and firmware. After the installation is complete, a
message is displayed prompting you to restart the system. After restarting, the DX system is installed and ready
for initial configuration.
5.
If you select Appliance Recovery as the recovery mode option:
Integrated Dell Remote Access Controller 6 (iDRAC6) User's
<recovermysystem> in the following message is the access code:
27