Dell PowerVault MD3000i Destek Notu - Sayfa 4

Depolama Dell PowerVault MD3000i için çevrimiçi göz atın veya pdf Destek Notu indirin. Dell PowerVault MD3000i 22 sayfaları. Configuration for vmware esx server software
Ayrıca Dell PowerVault MD3000i için: Ayarlama Kılavuzu (32 sayfalar), Yükseltme Kılavuzu (28 sayfalar), Kullanıcı Kılavuzu (46 sayfalar), Değiştirme Kılavuzu (4 sayfalar), Yapılandırma Kılavuzu (10 sayfalar)

Rules

When using the Microsoft or Linux iSCSI Initiator, IQN

identification must be used.

When using the Microsoft or Linux iSCSI Initiator, all

NICs in the same host will use the same iSCSI name. The

name will identify the host and the NICs will not be

identifiable.

Dell MPP drivers are required for multi-path support (refer

to Table 10). Linux open framework dm-mpp (multi-path)

drivers are not supported with the MD3000i.

Only the Dell Linux MPP multi-path driver should be

loaded on a Linux host server**

MD3000 and MD3200 series supported on a single Linux

host**

Microsoft "dynamic disks" are not supported by the

Microsoft iSCSI Initiator under Windows 2003. Windows

2008 native iSCSI Initiator supports dynamic disks.

Up to two Dell PowerVault MD1000 expansion enclosures

can be attached to the MD3000i for a total of 45 SAS and/or

SATA physical disks.

Attached MD1000 expansion enclosures must be set to

unified mode.

Virtual disk failover requires a dual-controller configuration

and at least one iSCSI session to each controller.

Link failover requires at least two iSCSI connections

established to the controller.

The enclosure can contain a mixture of SAS and SATA II

physical disks.

SAS and SATA disks cannot be mixed in a disk group.

A hot spare for a disk group must be a physical disk of equal

or greater size than any of the member disks.

The hot spare for a disk group with SAS physical disks must

be a SAS disk.

The hot spare for a disk group with SATA physical disks

must be a SATA disk.

When using out-of-band management with SMcli by

specifying the RAID Controller management port IP

addresses on the MD Storage Array, SMcli commands that

change the attributes of a virtual disk, virtual disk copy, or

snapshot virtual disk, must have management access to the

‫׀‬

Dell PowerVault Data MD3000i Support Matrix

First

Second

Gen.

√