Dell PowerVault MD3200i Series Dağıtım Kılavuzu - Sayfa 41

Depolama Dell PowerVault MD3200i Series için çevrimiçi göz atın veya pdf Dağıtım Kılavuzu indirin. Dell PowerVault MD3200i Series 41 sayfaları. Storage arrays
Ayrıca Dell PowerVault MD3200i Series için: Güncelleme Kılavuzu (32 sayfalar), Raf Kurulum Talimatları (2 sayfalar), Kullanıcı Kılavuzu (46 sayfalar), Destek Matrisi (12 sayfalar), Kurulum Kılavuzu (18 sayfalar), Bilgi Güncellemesi (1 sayfalar), Destek Matrisi (11 sayfalar), Destek Matrisi (17 sayfalar), Teknik El Kitabı (38 sayfalar), Beyaz Kitap (22 sayfalar), Manuel (16 sayfalar)

Dell PowerVault MD32xxi Configuration Guide for VMware ESX4.1 Server Software

255.255.255.0 10.10.5.255 00:50:56:7d:b5:f2 9000 65535 true

STATIC

We can determine the same information as was found from the GUI.

Now that we know the vmhba# and the vmk# we can map each VMkernel Port to the iSCSI Software

Initiator. This is done through the CLI by typing the following command:

esxcli swiscsi nic add –n vmk0 –d vmhba33

This will bind the vmk0 VMkernel port to the iSCSI Software Adapter vmhba33. We then proceed to bind

all of the other vmk# to the same vmhba.

esxcli swiscsi nic add –n vmk1 –d vmhba33

esxcli swiscsi nic add –n vmk2 –d vmhba33

esxcli swiscsi nic add –n vmk3 –d vmhba33

esxcli swiscsi nic add –n vmk4 –d vmhba33

esxcli swiscsi nic add –n vmk5 –d vmhba33

To verify that all of the vmk# are bound properly to the vmhba run the following command:

esxcli swiscsi nic list –d vmhba33

This will list all of the information for VMkernel ports that are assigned to the iSCSI Software Adapter.

Step A7: Connect to the Dell PowerVault Storage

Now that the iSCSI initiator has been configured properly, follow steps 7 through 10 above to assign the

new volumes and make them available for use.

One thing you will note is the increased number of connections seen in the connection tab of the volume

inside the PowerVault Storage administrator.

Page 39