Dell PowerVault MD3200i Series Kurulum Kılavuzu - Sayfa 13

Depolama Dell PowerVault MD3200i Series için çevrimiçi göz atın veya pdf Kurulum Kılavuzu indirin. Dell PowerVault MD3200i Series 18 sayfaları. Storage arrays
Ayrıca Dell PowerVault MD3200i Series için: Dağıtım Kılavuzu (41 sayfalar), Güncelleme Kılavuzu (32 sayfalar), Raf Kurulum Talimatları (2 sayfalar), Kullanıcı Kılavuzu (46 sayfalar), Destek Matrisi (12 sayfalar), Bilgi Güncellemesi (1 sayfalar), Destek Matrisi (11 sayfalar), Destek Matrisi (17 sayfalar), Teknik El Kitabı (38 sayfalar), Beyaz Kitap (22 sayfalar), Manuel (16 sayfalar)

Managing SMI-S Provider

Starting and Stopping the OpenPegasus CIM

Server

To start or stop the OpenPegasus CIM server:

Open the Services window and locate the cimserver service. Right-click

•

cimserver service and select start or stop.

•

In the command prompt:

To start the service, type: net start cimserver

To stop the service, type: net stop cimserver

To start or stop the OpenPegasus CIM server, on a terminal window:

To start the service, type: cimserver

To stop the service, type: cimserver -s

Adding or Removing a Storage Array From SMI-S

Provider

At installation, you are prompted to enter the IP addresses into a file. After

this initial setup, the SMI-enabled client must use the SMI-S Provider proxy

server system management profile to add or remove devices.

NOTE:

When a storage array is added, an IP address of only one of the

management ports of the storage array must be supplied (and not both

management ports). Entering the IP addresses for both management ports of a

single storage array causes unpredictable behavior of the SMI-S Provider.

Managing SMI-S Provider