Dell PowerVault MD3220 Series Kullanıcı Kılavuzu - Sayfa 21

Depolama Dell PowerVault MD3220 Series için çevrimiçi göz atın veya pdf Kullanıcı Kılavuzu indirin. Dell PowerVault MD3220 Series 46 sayfaları. Storage arrays
Ayrıca Dell PowerVault MD3220 Series için: Güncelleme Kılavuzu (32 sayfalar), Raf Kurulum Talimatları (2 sayfalar), Dağıtım Kılavuzu (38 sayfalar), Bilgi Güncellemesi (1 sayfalar), Teknik El Kitabı (40 sayfalar), Dağıtım Kılavuzu (38 sayfalar), Dağıtım Kılavuzu (38 sayfalar)

Figure 13. Port Name Binding

2 Using the vSphere CLI, connect the software iSCSI initiator to the iSCSI

VMkernel ports. Repeat this command for each port.

esxcli swiscsi nic add -n <port_name> -d <vmhba>

3 Verify that the ports were added to the software iSCSI initiator by running

the following command:

esxcli swiscsi nic list -d <vmhba>

4 Use the vSphere Client to rescan the software iSCSI initiator.

5 To disconnect the software iSCSI initiator from the ports, run the

following command:

esxcli swiscsi nic remove -n <port_name> -d

<vmhba>

If there are active iSCSI sessions between your host and targets,

discontinue them before running this command. You can do so by

removing static targets that the ports use from the vSphere Client.

esxcli swiscsi nic remove -n <port_name> -d

<vmhba>

Example 2: Connecting Software iSCSI Initiator to Two VMkernel Ports

This example shows how to connect the software iSCSI initiator vmhba33 to

VMkernel ports vmk1 and vmk2.

1 Connect vmhba33 to vmk1:

esxcli swiscsi nic add -n vmk1 -d vmhba33

2 Connect vmhba33 to vmk2:

esxcli swiscsi nic add -n vmk2 -d vmhba33

Dell MD Storage Array vCenter Plug-in